Difficulty

Difficult

Steps

7

Time Required

                          15 - 20 minutes

Sections

2

  • Speakers
  • 5 steps
  • Internal wiring components
  • 2 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackAstro A40 TR

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Speakers
  • To access the speakers you need to disassemble the earpiece. First remove the foam ear piece by simply pinching the padding and pulling lightly until the magnets disengage.

To access the speakers you need to disassemble the earpiece. First remove the foam ear piece by simply pinching the padding and pulling lightly until the magnets disengage.

1024

Step 2

  • Remove the dust cover located on the speaker. Use the corner of the spudger to peel underneath the cover until you can lift it by hand. The cover is held onto the device with adhesive and should be removed slowly.

Remove the dust cover located on the speaker. Use the corner of the spudger to peel underneath the cover until you can lift it by hand. The cover is held onto the device with adhesive and should be removed slowly.

Step 3

  • Take off the front cover by removing the four screws located in a square formation on the surface of the device. Use the J00 Philips driver listed in the device page.

Take off the front cover by removing the four screws located in a square formation on the surface of the device. Use the J00 Philips driver listed in the device page.

Step 4

  • Locate the three small screws under the speaker. Use the J00 Philips Driver to remove them.

Locate the three small screws under the speaker. Use the J00 Philips Driver to remove them.

Step 5

  • If your issue is asking for the complete replacement of the speaker or the motherboard, un-solder the old components and replace with new speaker by re-soldering.
  • Check out this useful guide on how to solder and desolder connections if soldering is new to you.

If your issue is asking for the complete replacement of the speaker or the motherboard, un-solder the old components and replace with new speaker by re-soldering.

Check out this useful guide on how to solder and desolder connections if soldering is new to you.

Step 6

              Internal wiring components
  • Untie the disconnected wiring harness.

Untie the disconnected wiring harness.

Step 7

  • Pull the black wire out of the hole in the device.

Pull the black wire out of the hole in the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 2 other contributors 


                    Mike

Member since: 10/20/2016

430 Reputation

                                      3 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       UMass Dartmouth, Team 6-5, Martin Fall 2016                        

                                                  Member of UMass Dartmouth, Team 6-5, Martin Fall 2016 



                    UMASSD-MARTIN-F16S6G5                     


                                            3 Members                     


                                            10 Guides authored