Difficulty

Moderate

Steps

8

Time Required

                          15 minutes

Sections

4

  • Panel Dial
  • 2 steps
  • Outer Casing
  • 3 steps
  • Motherboard
  • 2 steps
  • Control Button
  • 1 step

Flags

0

  • BackAstro Mixamp

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Panel Dial
  • Grip the dial tightly and pull straight off the device.
  • Repeat for the second dial

Grip the dial tightly and pull straight off the device.

Repeat for the second dial

1024

Step 2

  • Using tweezers, remove the spacer nuts and washers from each dial post.

Using tweezers, remove the spacer nuts and washers from each dial post.

Step 3

              Outer Casing
  • Before opening your device, ensure the device is not on or connected to the charging cable.
  • Insert a plastic opening tool into the seam between the rubber foot and plastic casing.
  • Pull the rubber foot free of the plastic casing.

Before opening your device, ensure the device is not on or connected to the charging cable.

Insert a plastic opening tool into the seam between the rubber foot and plastic casing.

Pull the rubber foot free of the plastic casing.

Step 4

  • Use a screwdriver to remove the screw from the rear casing.

Use a screwdriver to remove the screw from the rear casing.

Step 5

  • Gently lift the rear casing from the device.

Gently lift the rear casing from the device.

Step 6

              Motherboard
  • Remove the four screws that hold the motherboard in place.
  • Only touch the edges of the motherboard. Touching the surface can damage the motherboard.

Remove the four screws that hold the motherboard in place.

Only touch the edges of the motherboard. Touching the surface can damage the motherboard.

Step 7

  • Gently pull the motherboard from the front cover.

Gently pull the motherboard from the front cover.

Step 8

              Control Button
  • Gently insert a metal spudger under a control button housing.
  • Do not pry the button housing from the front panel, this can cause damage to the button.
  • Rotate the control button around the marked pin.

Gently insert a metal spudger under a control button housing.

Do not pry the button housing from the front panel, this can cause damage to the button.

Rotate the control button around the marked pin.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 1 other contributor 


                    Hope Burns

Member since: 10/29/2016

741 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       IUPUI, Team 3-3, Wilson Fall 2016                        

                                                  Member of IUPUI, Team 3-3, Wilson Fall 2016 



                    IUPUI-WILSON-F16S3G3                     


                                            3 Members                     


                                            5 Guides authored