Difficulty

Easy

Steps

8

Time Required

                          15 - 20 minutes

Sections

2

  • Keyboard Panel
  • 3 steps
  • Display
  • 5 steps

Flags

1

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackAsus Chromebook C300MA-DH02

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Keyboard Panel
  • Flip the Chromebook over so that the underside is facing up.
  • Using the Phillips PH #000 screwdriver, remove the 11 “4mm” screws on the back of the device.

Flip the Chromebook over so that the underside is facing up.

Using the Phillips PH #000 screwdriver, remove the 11 “4mm” screws on the back of the device.

1024

Step 2

  • Wedge the plastic opening tool between the bottom cover of the laptop and the keyboard panel.
  • Apply pressure and move the plastic opening tool around the border of the laptop until it pops out.

Wedge the plastic opening tool between the bottom cover of the laptop and the keyboard panel.

Apply pressure and move the plastic opening tool around the border of the laptop until it pops out.

Step 3

  • Once the keyboard panel pops out, slowly move it upwards so that the keyboard connection is visible.
  • Remove the keyboard connection from the motherboard by pulling it outwards from the connector.

Once the keyboard panel pops out, slowly move it upwards so that the keyboard connection is visible.

Remove the keyboard connection from the motherboard by pulling it outwards from the connector.

Step 4

              Display
  • Remove the hinge protector by using the plastic opening tool to gently lift it up. It should come up easily.

Remove the hinge protector by using the plastic opening tool to gently lift it up. It should come up easily.

Step 5

  • Using the plastic opening tool, separate the display cover bracket from the back of the display. Start from the top.

Using the plastic opening tool, separate the display cover bracket from the back of the display. Start from the top.

Step 6

  • Remove the (4) four “4mm” screws in each corner that hold the display using the Phillips #000 screwdriver.

Remove the (4) four “4mm” screws in each corner that hold the display using the Phillips #000 screwdriver.

Step 7

  • Lower the display to allow access to connector in back.

Lower the display to allow access to connector in back.

Step 8

  • Lift the tape covering the connector with the tweezers.
  • Gently remove the display connector from the motherboard.

Lift the tape covering the connector with the tweezers.

Gently remove the display connector from the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Zachary Leonard

Member since: 10/02/2017

304 Reputation

                                      3 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       USF Tampa, Team S6-G4, Remmell Fall 2017                        

                                                  Member of USF Tampa, Team S6-G4, Remmell Fall 2017 



                    USFT-REMMELL-F17S6G4                     


                                            4 Members                     


                                            12 Guides authored