Difficulty

Moderate

Steps

6

Time Required

                          5 - 15 minutes

Sections

1

  • Back Panel
  • 6 steps

Flags

0

  • BackASUS Eee Pad Transformer

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Use T5 Torx Screwdriver to remove two 4.5 millimeter T5 screws on either side of the port on the bottom of the tablet.

Use T5 Torx Screwdriver to remove two 4.5 millimeter T5 screws on either side of the port on the bottom of the tablet.

1024

Step 2

  • Use the Plastic Opening Tool to pry between the main tablet body and the outer rim casing. Remove the outer rim casing by prying all the way around the device and pulling the rim upward.
  • The physical buttons are located on the outside of the rim on the right side, proceed with the guide to locate internal buttons.

Use the Plastic Opening Tool to pry between the main tablet body and the outer rim casing. Remove the outer rim casing by prying all the way around the device and pulling the rim upward.

The physical buttons are located on the outside of the rim on the right side, proceed with the guide to locate internal buttons.

Step 3

  • Remove the four 2 millimeter Phillips #00 screws at the corners of the tablet.

Remove the four 2 millimeter Phillips #00 screws at the corners of the tablet.

Step 4

  • Use a Phillips #00 Screwdriver to remove the three 3 millimeter screws securing the front panel to the back panel found above the camera area, on the top portion of the tablet.

Use a Phillips #00 Screwdriver to remove the three 3 millimeter screws securing the front panel to the back panel found above the camera area, on the top portion of the tablet.

Step 5

  • Use a Phillips #00 Screwdriver to remove the three 3 millimeter screws securing the front panel to the back panel found on the bottom portion of the tablet near the port.

Use a Phillips #00 Screwdriver to remove the three 3 millimeter screws securing the front panel to the back panel found on the bottom portion of the tablet near the port.

Step 6

  • Remove back panel by pulling away from the remaining device.

Remove back panel by pulling away from the remaining device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 6 other contributors 


                    Sandy Babich

Member since: 09/23/2014

1,823 Reputation

                                      5 Guides authored                  



                       Badges:
                       18







                                                        +15 more badges

Team

                       Cal Poly, Team 13-9, Forte Fall 2014                        

                                                  Member of Cal Poly, Team 13-9, Forte Fall 2014 



                    CPSU-FORTE-F14S13G9                     


                                            5 Members                     


                                            12 Guides authored

Cathy Madzimure - Mar 22, 2018

Reply

what can I use to stick back the metalic edge?