Difficulty
Moderate
Steps
8
Time Required
15 - 30 minutes
Sections
2
- Back Panel
- 6 steps
- Buttons
- 2 steps
Flags
0
BackASUS Eee Pad Transformer
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Use T5 Torx Screwdriver to remove two 4.5 millimeter T5 screws on either side of the port on the bottom of the tablet.
Use T5 Torx Screwdriver to remove two 4.5 millimeter T5 screws on either side of the port on the bottom of the tablet.
1024
Step 2
- Use the Plastic Opening Tool to pry between the main tablet body and the outer rim casing. Remove the outer rim casing by prying all the way around the device and pulling the rim upward.
- The physical buttons are located on the outside of the rim on the right side, proceed with the guide to locate internal buttons.
Use the Plastic Opening Tool to pry between the main tablet body and the outer rim casing. Remove the outer rim casing by prying all the way around the device and pulling the rim upward.
The physical buttons are located on the outside of the rim on the right side, proceed with the guide to locate internal buttons.
Step 3
- Remove the four 2 millimeter Phillips #00 screws at the corners of the tablet.
Remove the four 2 millimeter Phillips #00 screws at the corners of the tablet.
Step 4
- Use a Phillips #00 Screwdriver to remove the three 3 millimeter screws securing the front panel to the back panel found above the camera area, on the top portion of the tablet.
Use a Phillips #00 Screwdriver to remove the three 3 millimeter screws securing the front panel to the back panel found above the camera area, on the top portion of the tablet.
Step 5
- Use a Phillips #00 Screwdriver to remove the three 3 millimeter screws securing the front panel to the back panel found on the bottom portion of the tablet near the port.
Use a Phillips #00 Screwdriver to remove the three 3 millimeter screws securing the front panel to the back panel found on the bottom portion of the tablet near the port.
Step 6
- Remove back panel by pulling away from the remaining device.
Remove back panel by pulling away from the remaining device.
Step 7
Remove button screws
- Use a Phillips #00 Screwdriver to remove the three 3 millimeter screws securing the buttons to the back panel.
Use a Phillips #00 Screwdriver to remove the three 3 millimeter screws securing the buttons to the back panel.
Step 8
Locate and lift button clip
- Use Plastic Opening Tool to pry off the clip located towards the bottom of the button component near the metallic strip with a blue end, capped by the black button clip.
- Remove button component by pulling straight outward from the device.
Use Plastic Opening Tool to pry off the clip located towards the bottom of the button component near the metallic strip with a blue end, capped by the black button clip.
Remove button component by pulling straight outward from the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 8 other contributors
Joe Payne
Member since: 09/29/2014
520 Reputation
1 Guide authored
Badges:
16
+13 more badges
Team
Cal Poly, Team 13-9, Forte Fall 2014
Member of Cal Poly, Team 13-9, Forte Fall 2014
CPSU-FORTE-F14S13G9
5 Members
12 Guides authored
