Difficulty

Moderate

Steps

8

Time Required

                          30 minutes

Sections

2

  • Back Panel
  • 6 steps
  • GPS Antenna
  • 2 steps

Flags

0

  • BackASUS Eee Pad Transformer

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Use T5 Torx Screwdriver to remove two 4.5 millimeter T5 screws on either side of the port on the bottom of the tablet.

Use T5 Torx Screwdriver to remove two 4.5 millimeter T5 screws on either side of the port on the bottom of the tablet.

1024

Step 2

  • Use the Plastic Opening Tool to pry between the main tablet body and the outer rim casing. Remove the outer rim casing by prying all the way around the device and pulling the rim upward.
  • The physical buttons are located on the outside of the rim on the right side, proceed with the guide to locate internal buttons.

Use the Plastic Opening Tool to pry between the main tablet body and the outer rim casing. Remove the outer rim casing by prying all the way around the device and pulling the rim upward.

The physical buttons are located on the outside of the rim on the right side, proceed with the guide to locate internal buttons.

Step 3

  • Remove the four 2 millimeter Phillips #00 screws at the corners of the tablet.

Remove the four 2 millimeter Phillips #00 screws at the corners of the tablet.

Step 4

  • Use a Phillips #00 Screwdriver to remove the three 3 millimeter screws securing the front panel to the back panel found above the camera area, on the top portion of the tablet.

Use a Phillips #00 Screwdriver to remove the three 3 millimeter screws securing the front panel to the back panel found above the camera area, on the top portion of the tablet.

Step 5

  • Use a Phillips #00 Screwdriver to remove the three 3 millimeter screws securing the front panel to the back panel found on the bottom portion of the tablet near the port.

Use a Phillips #00 Screwdriver to remove the three 3 millimeter screws securing the front panel to the back panel found on the bottom portion of the tablet near the port.

Step 6

  • Remove back panel by pulling away from the remaining device.

Remove back panel by pulling away from the remaining device.

Step 7

              GPS Antenna
  • Remove the GPS antenna using the spudger.

Remove the GPS antenna using the spudger.

Step 8

  • Use a pair of tweezers to disconnect the two wires.
  • Remove the GPS Antenna from the device.

Use a pair of tweezers to disconnect the two wires.

Remove the GPS Antenna from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Rillian Dennis

Member since: 11/06/2019

202 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       IUPUI, Team S1-G5, Harley Fall 2019                        

                                                  Member of IUPUI, Team S1-G5, Harley Fall 2019 



                    IUPUI-HARLEY-F19S1G5                     


                                            3 Members                     


                                            2 Guides authored