Difficulty

Easy

Steps

8

Time Required

                          10 minutes

Sections

2

  • Battery
  • 5 steps
  • LED Screen Panel Chip
  • 3 steps

Flags

0

  • BackAsus EeeBook X205TA

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Unscrew all ten 2mm screws located on the bottom of the laptop using a Phillips #2 screwdriver.

Unscrew all ten 2mm screws located on the bottom of the laptop using a Phillips #2 screwdriver.

1024

Step 2

  • Insert the plastic opening tool in the crevice between the back of the laptop and the rest of the case.
  • Carefully pry open the case from several points.
  • Slowly remove the back of the laptop, revealing the parts inside.

Insert the plastic opening tool in the crevice between the back of the laptop and the rest of the case.

Carefully pry open the case from several points.

Slowly remove the back of the laptop, revealing the parts inside.

Step 3

  • Unscrew all six 2mm screws using Philips #2 screws along the edges of the L-Shaped battery.
  • Any tape or cords that run along the battery should be carefully pushed to the side.

Unscrew all six 2mm screws using Philips #2 screws along the edges of the L-Shaped battery.

Any tape or cords that run along the battery should be carefully pushed to the side.

Step 4

  • Disconnect the battery from the motherboard by pulling the No-Fuss Ribbon cables out of the connector.

Disconnect the battery from the motherboard by pulling the No-Fuss Ribbon cables out of the connector.

Step 5

  • Carefully lift the battery out of the laptop.

Carefully lift the battery out of the laptop.

Step 6

              LED Screen Panel Chip
  • Locate and lift the tabs from the LED/motherboard ribbon cable.
  • Remove the cable.

Locate and lift the tabs from the LED/motherboard ribbon cable.

Remove the cable.

Step 7

  • Unscrew the 1 JIS 2mm screw with the J0 bit.

Unscrew the 1 JIS 2mm screw with the J0 bit.

Step 8

  • Remove the chip.

Remove the chip.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Rachael

Member since: 03/20/2017

125 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       IUPUI, Team S3-G4, Baechle Spring 2017                        

                                                  Member of IUPUI, Team S3-G4, Baechle Spring 2017 



                    IUPUI-BAECHLE-S17S3G4                     


                                            4 Members                     


                                            6 Guides authored