Difficulty
Easy
Steps
2
Time Required
10 minutes
Sections
1
- RAM
- 2 steps
Flags
0
BackAsus F555LA-AB31
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
RAM
- Remove the Phillips #0 screw holding the RAM access panel in place.
- Gently lift up on the edge of the panel to remove it.
Remove the Phillips #0 screw holding the RAM access panel in place.
Gently lift up on the edge of the panel to remove it.
1024
Step 2
- With the panel removed, The single upgradable RAM slot is easily accessible.
- If RAM is already installed, it can be removed by gently pulling the retainers sideways away from the RAM to release it.
- To install RAM, slide the DIMM into the socket at an angle of approximately 20 degrees from flat. Make sure the notch in the RAM module aligns with the notch in the socket. Gently push down on the RAM module until the retainers click into place.
With the panel removed, The single upgradable RAM slot is easily accessible.
If RAM is already installed, it can be removed by gently pulling the retainers sideways away from the RAM to release it.
To install RAM, slide the DIMM into the socket at an angle of approximately 20 degrees from flat. Make sure the notch in the RAM module aligns with the notch in the socket. Gently push down on the RAM module until the retainers click into place.
To reassemble your device, reinstall the access panel by following these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Jordan Renteria
Member since: 04/04/2019
335 Reputation
2 Guides authored
Badges:
10
+7 more badges
Team
Oregon Institute of Technology, Team S1-G1, Lancaster Spring 2019
Member of Oregon Institute of Technology, Team S1-G1, Lancaster Spring 2019
OIT-LANCASTER-S19S1G1
4 Members
6 Guides authored