Difficulty

Moderate

Steps

8

Time Required

                          10 minutes

Sections

2

  • Battery
  • 3 steps
  • Left and Right Speaker Bar
  • 5 steps

Flags

0

  • BackAsus G750JW-BBI7N05

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Power off and unplug your laptop, then turn it over.

Power off and unplug your laptop, then turn it over.

1024

Step 2

  • Slide the battery release latch all the way to the right. This will cause the battery to “pop” out slightly.

Slide the battery release latch all the way to the right. This will cause the battery to “pop” out slightly.

Step 3

  • Remove the battery from its compartment.

Remove the battery from its compartment.

Step 4

              Left and Right Speaker Bar
  • Remove the rubber stoppers in the top left and right corners to expose two 9mm Phillips #00 screws. Unscrew and remove them.
  • Unscrew and remove the three 4mm Phillips #00 screws inside the battery compartment.

Remove the rubber stoppers in the top left and right corners to expose two 9mm Phillips #00 screws. Unscrew and remove them.

Unscrew and remove the three 4mm Phillips #00 screws inside the battery compartment.

Step 5

  • Carefully turn the laptop right-side up.
  • Using an opening tool, pry the outer edges of the hinge cover up and away from the laptop.
  • The hinge cover, located at the back of the laptop, is the long plastic plate that covers the hinges and speakers.

Carefully turn the laptop right-side up.

Using an opening tool, pry the outer edges of the hinge cover up and away from the laptop.

The hinge cover, located at the back of the laptop, is the long plastic plate that covers the hinges and speakers.

Step 6

  • Without disconnecting the speaker cable, set the hinge cover upside-down.
  • Hold the speaker cable by its white connector, then pull to unplug it from the motherboard.
  • You may need to apply some force, as these connectors can be difficult to unplug.

Without disconnecting the speaker cable, set the hinge cover upside-down.

Hold the speaker cable by its white connector, then pull to unplug it from the motherboard.

You may need to apply some force, as these connectors can be difficult to unplug.

Step 7

  • The speaker is attached to the hinge cover by four 3.5mm Phillips #00 screws. Unscrew and remove them.

The speaker is attached to the hinge cover by four 3.5mm Phillips #00 screws. Unscrew and remove them.

Step 8

  • Lift the speaker to remove it.

Lift the speaker to remove it.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 2 other contributors 


                    Stephanie Asling

Member since: 10/05/2017

424 Reputation

                                      2 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Portland State University, Team S1-G1, Read Fall 2017                        

                                                  Member of Portland State University, Team S1-G1, Read Fall 2017 



                    PSUN-READ-F17S1G1                     


                                            2 Members                     


                                            3 Guides authored