Difficulty

Moderate

Steps

11

Time Required

                          15 - 20 minutes

Sections

3

  • Speaker
  • 5 steps
  • Screen
  • 3 steps
  • Camera
  • 3 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackAsus PadFone X mini

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Speaker
  • With the phone facing down, look at the bottom right side corner and there should be a groove. Use a plastic opening tool and lift up to remove outside cover.
  • This is not the cover with the speaker attached.

With the phone facing down, look at the bottom right side corner and there should be a groove. Use a plastic opening tool and lift up to remove outside cover.

This is not the cover with the speaker attached.

1024

Step 2

  • Lift the battery out from the top of the device.

Lift the battery out from the top of the device.

Step 3

  • Around the perimeter, there should be 10 2 mm T5 Torx screws. Take them out.
  • Remove the cover.

Around the perimeter, there should be 10 2 mm T5 Torx screws. Take them out.

Remove the cover.

Step 4

  • Turn the cover over.
  • The speaker is attached to the inside of the cover and to the right of the camera hole.

Turn the cover over.

The speaker is attached to the inside of the cover and to the right of the camera hole.

Step 5

  • Remove speaker with standard tweezers to minimize damage, and replace.

Remove speaker with standard tweezers to minimize damage, and replace.

Step 6

              Screen
  • Detach the black connector on the left hand side of the motherboard.
  • Don’t completely remove the black connector.

Detach the black connector on the left hand side of the motherboard.

Don’t completely remove the black connector.

Step 7

  • Disconnect silver connector from the motherboard. It is located on the left hand side above the black connector.

Disconnect silver connector from the motherboard. It is located on the left hand side above the black connector.

Step 8

  • Remove motherboard and replace screen.

Remove motherboard and replace screen.

Step 9

              Camera
  • Turn over the motherboard.

Turn over the motherboard.

Step 10

  • Using tweezers pull out the connector that connects the camera to the motherboard.

Using tweezers pull out the connector that connects the camera to the motherboard.

Step 11

  • Take out the camera.
  • Put in the new camera by sliding the camera connector into the receiver.

Take out the camera.

Put in the new camera by sliding the camera connector into the receiver.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    James Jackson

Member since: 09/18/2018

97 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       University of North Texas, Team S4-G2, Raign Fall 2018                        

                                                  Member of University of North Texas, Team S4-G2, Raign Fall 2018 



                    UNT-RAIGN-F18S4G2                     


                                            4 Members                     


                                            8 Guides authored