Difficulty

Moderate

Steps

9

Time Required

                          9 - 10 minutes

Sections

3

  • Back Cover
  • 3 steps
  • Battery
  • 3 steps
  • Wi-Fi Card
  • 3 steps

Flags

0

  • BackAsus Q200E-CT144H

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • To start, turn off the laptop and disconnect the power cable.
  • If the computer is on or plugged in, it could cause electric shock.
  • Flip the laptop over so the back panel is visible.

To start, turn off the laptop and disconnect the power cable.

If the computer is on or plugged in, it could cause electric shock.

Flip the laptop over so the back panel is visible.

1024

Step 2

  • Remove the 9 screws holding the cover in place by taking a Phillips #00 Screwdriver and turning it counterclockwise.

Remove the 9 screws holding the cover in place by taking a Phillips #00 Screwdriver and turning it counterclockwise.

Step 3

  • Use an iFixit opening tool to lift the back cover and remove it from the laptop.

Use an iFixit opening tool to lift the back cover and remove it from the laptop.

Step 4

              Battery
  • Remove the battery connector by using tweezers to lift up on it.

Remove the battery connector by using tweezers to lift up on it.

Step 5

  • Remove the nine Phillips #00 screws that hold the battery in place.
  • There is one 9.2mm screw, four 4.7mm screws, and four 5.7mm screws.

Remove the nine Phillips #00 screws that hold the battery in place.

There is one 9.2mm screw, four 4.7mm screws, and four 5.7mm screws.

Step 6

  • Remove the battery from the battery bay.

Remove the battery from the battery bay.

Step 7

              Wi-Fi Card
  • Use tweezers or your fingers to disconnect the Wi-Fi card’s power connector.

Use tweezers or your fingers to disconnect the Wi-Fi card’s power connector.

Step 8

  • Unscrew the single 4.7mm screw with a Phillips #00 screwdriver.

Unscrew the single 4.7mm screw with a Phillips #00 screwdriver.

Step 9

  • Remove the card from its bay.

Remove the card from its bay.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Kirsti Wattles

Member since: 09/16/2019

689 Reputation

                                      6 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Embry-Riddle Aeronautical University, Team S8-G2, Salas Fall 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S8-G2, Salas Fall 2019 



                    ERAU-SALAS-F19S8G2                     


                                            3 Members                     


                                            6 Guides authored