Difficulty

Moderate

Steps

5

Time Required

                          10 minutes

Sections

1

  • Battery
  • 5 steps

Flags

0

  • BackASUS Q324UA-BHI7T17

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Remove all 10 Phillips screws on the backplate.
  • All 10 screws are 0.55 inches and 20 mm in diameter.

Remove all 10 Phillips screws on the backplate.

All 10 screws are 0.55 inches and 20 mm in diameter.

1024

Step 2

  • Carefully remove the backplate using the plastic opening tool.

Carefully remove the backplate using the plastic opening tool.

Step 3

  • Locate the battery near the bottom.

Locate the battery near the bottom.

Step 4

  • Next, lift up the battery connector from the laptop in the upper left side of the battery, using tweezers or spudger.
  • Make sure to complete this step with caution, because if the battery is not unplugged, the motherboard may shock you.

Next, lift up the battery connector from the laptop in the upper left side of the battery, using tweezers or spudger.

Make sure to complete this step with caution, because if the battery is not unplugged, the motherboard may shock you.

Step 5

  • Remove the six screws holding in the battery with a Phillips #0 screwdriver.
  • Once battery is lifted out and removed, proper dispose of the old battery.
  • Each screw is 0.5 cm in length and 0.5 cm in diameter.

Remove the six screws holding in the battery with a Phillips #0 screwdriver.

Once battery is lifted out and removed, proper dispose of the old battery.

Each screw is 0.5 cm in length and 0.5 cm in diameter.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Scott Santiago

Member since: 10/17/2017

534 Reputation

                                      5 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       UMass Dartmouth, Team S1-G1, Simcock Fall 2017                        

                                                  Member of UMass Dartmouth, Team S1-G1, Simcock Fall 2017 



                    UMASSD-SIMCOCK-F17S1G1                     


                                            3 Members                     


                                            5 Guides authored

Scott Gartner - Jan 7, 2019

Reply

The screws in this laptop are not all the same length. Unfortunately, I only kept track of some of them as I didn’t notice that they weren’t all the same until I had most of them out. I know that two of the longer screws go in the back between the back feet, but I’m not 100% sure of the others.

eddygblk - Oct 8, 2020

Reply

where can i purchase this battery?

Gil Hutchinson - Dec 1, 2020

Reply

I removed the cover successfully (including noting where the long and short screws are located) but cannot get the #0 Phillips screwdriver to fit into those tiny cross shaped slots in the screws holding the battery in. It seems to be too big or the wrong shape, and I am really concerned about stripping the heads by tying to force it too much. Maybe a small regular flat head that will fit into the grooves?