Asus R510La Rs71 Motherboard Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          30 minutes

Sections

Battery
2 steps
Hard Drive
4 steps
RAM
4 steps
Motherboard
10 steps

Flags

BackAsus R510LA-RS71
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Locate the locking mechanisms that keep the battery in place and slide them outwards.
The right mechanism will lock in place, the left one you will need to hold in place.

Locate the locking mechanisms that keep the battery in place and slide them outwards.

The right mechanism will lock in place, the left one you will need to hold in place.

1024

Step 2

Use your right thumb to slide the right side of the battery out, then the left side.

Use your right thumb to slide the right side of the battery out, then the left side.

Step 3

              Hard Drive

Remove the bottom left and right 12.7mm screws using a JIS 00 screwdriver.

Remove the bottom left and right 12.7mm screws using a JIS 00 screwdriver.

Step 4

Slide back and remove the protective plating on the back of the laptop.

Slide back and remove the protective plating on the back of the laptop.

Step 5

Again with the JIS 00, unscrew the three 5.7mm screws holding the hard drive in place. These can be found on small brackets on the four corners of the drive.

Again with the JIS 00, unscrew the three 5.7mm screws holding the hard drive in place. These can be found on small brackets on the four corners of the drive.

Step 6

Slide the hard drive to the left, then remove it by lifting it from the compartment it is resting in.

Slide the hard drive to the left, then remove it by lifting it from the compartment it is resting in.

Step 7

RAM

Using the JIS 00 screwdriver, remove the bottom left/right 12.7mm screws located on the back of the laptop.

Using the JIS 00 screwdriver, remove the bottom left/right 12.7mm screws located on the back of the laptop.

Step 8

Slide and lift off the bottom cover.

Slide and lift off the bottom cover.

Step 9

There should be an exposed area located on the right center of the bottom of the revealed compartment. Move the silver brackets holding the RAM to the side. The RAM will pop out of its hold.

There should be an exposed area located on the right center of the bottom of the revealed compartment. Move the silver brackets holding the RAM to the side. The RAM will pop out of its hold.

Step 10

Remove the RAM

Remove the RAM

Step 11

              Motherboard

With the Battery, Hard Drive, and RAM removed, the laptop should look like this
Using the JIS 00 screwdriver, remove the 4.7mm screws that are highlighted, there are two in the battery compartment, two on the outsides of the battery locks, and five around the RAM.

With the Battery, Hard Drive, and RAM removed, the laptop should look like this

Using the JIS 00 screwdriver, remove the 4.7mm screws that are highlighted, there are two in the battery compartment, two on the outsides of the battery locks, and five around the RAM.

Step 12

With all screws removed, slide fingers in the crease, separating the keyboard from the bottom of the computer
With the laptop opened, as shown in the second picture, the bottom is the keyboard cover, it should be completely detached, take it and set it aside

With all screws removed, slide fingers in the crease, separating the keyboard from the bottom of the computer

With the laptop opened, as shown in the second picture, the bottom is the keyboard cover, it should be completely detached, take it and set it aside

Step 13

Flip the laptop over, so it is sitting as it would if you were using it
Using the JIS 00 screwdriver, remove all of the 5.7 mm screws remaining in the motherboard and around the fan

Flip the laptop over, so it is sitting as it would if you were using it

Using the JIS 00 screwdriver, remove all of the 5.7 mm screws remaining in the motherboard and around the fan

Step 14

Ensure the screw keeping the disc drive in place is removed, then slide the drive out

Ensure the screw keeping the disc drive in place is removed, then slide the drive out

Step 15

Disconnect the chip under the fan, connected to the motherboard (you should have removed the screws in step 3)

Disconnect the chip under the fan, connected to the motherboard (you should have removed the screws in step 3)

Step 16

Remove the two blue and white ribbons
To disconnect them, flip the metal bracket that holds them in

Remove the two blue and white ribbons

To disconnect them, flip the metal bracket that holds them in

Step 17

Remove the gold wire from its port by pulling back the tape, then slide it up and out

Remove the gold wire from its port by pulling back the tape, then slide it up and out

Step 18

Remove the wires at the top left of the motherboard, they can just be pulled out

Remove the wires at the top left of the motherboard, they can just be pulled out

Step 19

To remove the motherboard, stick your fingers through the area where the ram is inserted, lifting it up
Then pull out to right at a slightly upwards angle

To remove the motherboard, stick your fingers through the area where the ram is inserted, lifting it up

Then pull out to right at a slightly upwards angle

Step 20

Some new motherboards are sold with a fan attached, if the replacement you have does not, then you will need to remove the fan from the current motherboard
To do this, flip the motherboard over once it is removed from the laptop and remove the screws from the bracket holding it in place and remove it

Some new motherboards are sold with a fan attached, if the replacement you have does not, then you will need to remove the fan from the current motherboard

To do this, flip the motherboard over once it is removed from the laptop and remove the screws from the bracket holding it in place and remove it

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Matthew Diaz

Member since: 02/15/2018

324 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       USF Tampa, Team S1-G6, Leahy Spring 2018                        

                                                  Member of USF Tampa, Team S1-G6, Leahy Spring 2018 



                    USFT-LEAHY-S18S1G6                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team