Asus Rog G750Jh Db71 Disassembly Repair Guide

Difficulty

Moderate

Steps

Time Required

                          30 minutes

Sections

Battery
2 steps
Asus ROG G750JH-DB71 Disassembly
7 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

BackAsus ROG G750JH-DB71
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Ensure the laptop is powered off and unplugged before beginning.
Flip the laptop over so the bottom case is facing up.

Ensure the laptop is powered off and unplugged before beginning.

Flip the laptop over so the bottom case is facing up.

1024

Step 2

Push the switch near the front of the laptop to release the battery from the computer.
Pull the battery out and away from the center of the computer.

Push the switch near the front of the laptop to release the battery from the computer.

Pull the battery out and away from the center of the computer.

Step 3

              Asus ROG G750JH-DB71 Disassembly

Use a spudger or your finger to lift up the plastic cover on back of the laptop.
Under the plastic cover is a captive screw; unscrew it using a Phillips #00 screwdriver.

Use a spudger or your finger to lift up the plastic cover on back of the laptop.

Under the plastic cover is a captive screw; unscrew it using a Phillips #00 screwdriver.

Step 4

Remove the cover.
If your goal is to replace/remove only the hard drive. You don’t have to complete the following disassembly steps and can go on to the hard drive replacement guide.

Remove the cover.

If your goal is to replace/remove only the hard drive. You don’t have to complete the following disassembly steps and can go on to the hard drive replacement guide.

Step 5

Remove the hard drive by unscrewing the 4.4 mm Phillips #00 screws.
Remove all of the plastic caps around the edges using a pick or flathead screwdriver, and remove the screws underneath them. (one 13 mm Phillips #00, six 8 mm Phillips #00)
Remove all of the screws underneath the cover removed previously. (six 8mm Phillips #00, three 1 mm Phillips #00)

Remove the hard drive by unscrewing the 4.4 mm Phillips #00 screws.

Remove all of the plastic caps around the edges using a pick or flathead screwdriver, and remove the screws underneath them. (one 13 mm Phillips #00, six 8 mm Phillips #00)

Remove all of the screws underneath the cover removed previously. (six 8mm Phillips #00, three 1 mm Phillips #00)

Step 6

Push on the metal tab with a flathead screwdriver or an iFixit tool to remove the CD rom. It is located below a previously removed screw.
Do not pull the CD rom out from the side before pushing the metal tab as it will only damage the cover.
Remove the three (4 mm Phillips #00) screws that were previously covered by the CD rom.

Push on the metal tab with a flathead screwdriver or an iFixit tool to remove the CD rom. It is located below a previously removed screw.

Do not pull the CD rom out from the side before pushing the metal tab as it will only damage the cover.

Remove the three (4 mm Phillips #00) screws that were previously covered by the CD rom.

Step 7

Once the screws are out and the CD rom is removed, the back cover can be taken off by hand.
Disconnect the speaker cables located in picture 1 and 2.
Remove two 8 mm Phillips #00 screws on each corner shown in picture 3.

Once the screws are out and the CD rom is removed, the back cover can be taken off by hand.

Disconnect the speaker cables located in picture 1 and 2.

Remove two 8 mm Phillips #00 screws on each corner shown in picture 3.

Step 8

Pry the keyboard gently using the iFixit prying tool.
Make sure to unhook the cables and wires from the keyboard gently in Picture 3.

Pry the keyboard gently using the iFixit prying tool.

Make sure to unhook the cables and wires from the keyboard gently in Picture 3.

Step 9

Now you can pull the keyboard off but make sure to do so carefully without damaging or scuffing any components.
Pull up and out at an angle as to avoid damaging the internals of the laptop.

Now you can pull the keyboard off but make sure to do so carefully without damaging or scuffing any components.

Pull up and out at an angle as to avoid damaging the internals of the laptop.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    James Mills

Member since: 10/25/2022

471 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       UMass Dartmouth, Team 5-5, Sinclaire Fall 2022                        

                                                  Member of UMass Dartmouth, Team 5-5, Sinclaire Fall 2022 



                    UMASSD-SINCLAIRE-F22S5G5                     


                                            4 Members                     


                                            6 Guides authored

Better Introduction#

Introduction#

What you need#

Team#

Better Introduction

Introduction

What you need

Team