Difficulty

Moderate

Steps

12

Time Required

                          30 minutes

Sections

1

  • RAM
  • 12 steps

Flags

0

  • BackAsus ROG G751JT-DH72

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              RAM
  • Lift up the rubber tab located in the upper-right corner of the backing plate.

Lift up the rubber tab located in the upper-right corner of the backing plate.

1024

Step 2

  • Use a Phillips #1 screwdriver to remove the 5.2 mm screw behind the rubber tap.

Use a Phillips #1 screwdriver to remove the 5.2 mm screw behind the rubber tap.

Step 3

  • Carefully pull the backing plate off. If you have a pry tool, you can pry on the edges carefully.

Carefully pull the backing plate off. If you have a pry tool, you can pry on the edges carefully.

Step 4

  • Use a Phillips #1 screwdriver to remove the 5mm screw on the right side.

Use a Phillips #1 screwdriver to remove the 5mm screw on the right side.

Step 5

  • Pull out the optical drive to revel the screws holding the laptop cover.

Pull out the optical drive to revel the screws holding the laptop cover.

Step 6

  • Remove all 10 5.2mm Phillips screws holding the main back cover using the Phillips #1 screwdriver.

Remove all 10 5.2mm Phillips screws holding the main back cover using the Phillips #1 screwdriver.

Step 7

  • Remove the four 5.2mm screws directly behind the backing plate using the Phillips #1 screwdriver.

Remove the four 5.2mm screws directly behind the backing plate using the Phillips #1 screwdriver.

Step 8

  • Flip over the laptop and pry the 2 vent covers off.

Flip over the laptop and pry the 2 vent covers off.

Step 9

  • Remove the two 6.8mm Phillips screws directly below the vent covers using the Phillips #1 screwdriver.

Remove the two 6.8mm Phillips screws directly below the vent covers using the Phillips #1 screwdriver.

Step 10

  • Pry along the edges of the keyboard to lift it up.
  • Be careful not to damage the ribbon connectors.

Pry along the edges of the keyboard to lift it up.

Be careful not to damage the ribbon connectors.

Step 11

  • Disconnect all 4 ribbon connectors with a tweezer.

Disconnect all 4 ribbon connectors with a tweezer.

Step 12

  • Carefully, pull on the side tabs to release the RAM card.

Carefully, pull on the side tabs to release the RAM card.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Anum Haidari

Member since: 10/22/2018

558 Reputation

                                      3 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       UC Davis, Team S7-G4, Lore Fall 2018                        

                                                  Member of UC Davis, Team S7-G4, Lore Fall 2018 



                    UCD-LORE-F18S7G4                     


                                            2 Members                     


                                            3 Guides authored