Difficulty

Moderate

Steps

5

Time Required

                          20 minutes

Sections

3

  • Back Panel
  • 2 steps
  • Battery
  • 2 steps
  • Solid State Drive
  • 1 step

Flags

0

  • BackAsus ROG Strix GL702VM-BHI7N09

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Flip the laptop over to the back panel, with the serial numbers facing up.
  • Using a Phillips #1 screwdriver, remove the ten 12 mm screws from the back panel.

Flip the laptop over to the back panel, with the serial numbers facing up.

Using a Phillips #1 screwdriver, remove the ten 12 mm screws from the back panel.

1024

Step 2

  • The snap seals don’t need a lot of pressure to open, and may break if forced. Be gentle with the opening tool.
  • Wedge the sharp edge of the plastic opening tool into the seam between the back panel and the rest of the laptop, then gently pry the panel up.
  • There will be a snapping sound as you remove the back panel, but that is just the seal loosening.
  • Continue breaking the seals by sliding the plastic opening tool around the entire laptop under the seam until the back panel is free.
  • Once you have broken all the seals, carefully lift the panel off.

The snap seals don’t need a lot of pressure to open, and may break if forced. Be gentle with the opening tool.

Wedge the sharp edge of the plastic opening tool into the seam between the back panel and the rest of the laptop, then gently pry the panel up.

There will be a snapping sound as you remove the back panel, but that is just the seal loosening.

Continue breaking the seals by sliding the plastic opening tool around the entire laptop under the seam until the back panel is free.

Once you have broken all the seals, carefully lift the panel off.

Step 3

              Battery
  • Unplug the battery from the motherboard.

Unplug the battery from the motherboard.

Step 4

  • Unscrew the 3.8 mm Phillips #1 screw on the top right hand corner of the battery.
  • Lift battery from laptop frame.

Unscrew the 3.8 mm Phillips #1 screw on the top right hand corner of the battery.

Lift battery from laptop frame.

Step 5

              Solid State Drive
  • Using a Phillips #1 screwdriver, remove the 4mm screw holding down the SSD.
  • Slide the SSD out from the connection slot.

Using a Phillips #1 screwdriver, remove the 4mm screw holding down the SSD.

Slide the SSD out from the connection slot.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Cameron Richard

Member since: 09/16/2020

76 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       The Citadel Military College of South Carolina, Team S1-G3, Eggleston Fall 2020                        

                                                  Member of The Citadel Military College of South Carolina, Team S1-G3, Eggleston Fall 2020 



                    CMCSC-EGGLESTON-F20S1G3                     


                                            3 Members                     


                                            3 Guides authored