Difficulty

Difficult

Steps

5

Time Required

                          15 - 25 minutes

Sections

1

  • Display
  • 5 steps

Flags

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackAsus Transformer Pad TF300T Tablet

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Display
  • Disconnect the dock and make sure the power is turned off.
  • Use plastic opening tool to pry screen up and remove from outer casing.
  • Be gentle with the plastic opening tool when you reach the charging port as the thinner plastic could be broken easily.

Disconnect the dock and make sure the power is turned off.

Use plastic opening tool to pry screen up and remove from outer casing.

Be gentle with the plastic opening tool when you reach the charging port as the thinner plastic could be broken easily.

1024

Step 2

  • Pull up on the black circuit board protector.
  • Turn off the hard power switch before working with the tablet. Use a tool to slide the switch to the position marked “off”.
  • For most of the replacement operation, you do not have to remove the battery once you turned off the switch. Make sure that you do not short anything with the metal tools.

Pull up on the black circuit board protector.

Turn off the hard power switch before working with the tablet. Use a tool to slide the switch to the position marked “off”.

For most of the replacement operation, you do not have to remove the battery once you turned off the switch. Make sure that you do not short anything with the metal tools.

Step 3

  • Use a Phillips #00 screwdriver to remove the 3mm screws connecting the battery to the motherboard.
  • Use the same screwdriver to remove two 3mm screws connecting the clips.
  • Use tweezers to remove two wires connected from the battery to the motherboard.
  • Use the spudger to remove the battery from the case.

Use a Phillips #00 screwdriver to remove the 3mm screws connecting the battery to the motherboard.

Use the same screwdriver to remove two 3mm screws connecting the clips.

Use tweezers to remove two wires connected from the battery to the motherboard.

Use the spudger to remove the battery from the case.

Step 4

  • Use a Phillips #00 Screwdriver to remove the 3mm screws that connect the metal board with the screen.

Use a Phillips #00 Screwdriver to remove the 3mm screws that connect the metal board with the screen.

Step 5

  • Use a hairdryer on high and heat the edges of the screen. Melt the adhesive holding the screen to the casing of the tablet.
  • Take out the display away from the screen.

Use a hairdryer on high and heat the edges of the screen. Melt the adhesive holding the screen to the casing of the tablet.

Take out the display away from the screen.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Khairuz Zaki Md Rujhan

Member since: 05/22/2017

437 Reputation

                                      3 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       IUPUI, Team S2-G2, Wilson Summer 2017                        

                                                  Member of IUPUI, Team S2-G2, Wilson Summer 2017 



                    IUPUI-WILSON-SU17S2G2                     


                                            3 Members                     


                                            8 Guides authored