Difficulty
Easy
Steps
5
Time Required
15 minutes
Sections
1
- USB and Power Circuit Board
- 5 steps
Flags
0
BackASUS Transformer Book Flip TP500LA
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
USB and Power Circuit Board
- Remove the ten 10.7 mm screws using a Phillips #0 screwdriver from the back of the laptop.
Remove the ten 10.7 mm screws using a Phillips #0 screwdriver from the back of the laptop.
1024
Step 2
- Using a heavy-duty spudger, pry the back cover up from the frame and completely remove.
Using a heavy-duty spudger, pry the back cover up from the frame and completely remove.
Step 3
- Remove the two 4.7 mm screws with the Phillips #0 screwdriver.
Remove the two 4.7 mm screws with the Phillips #0 screwdriver.
Step 4
- Using a spudger or fingernail, flip up the white plastic latch securing the ribbon cable.
- After the latch is released remove the ribbon cable and clear it from the board.
Using a spudger or fingernail, flip up the white plastic latch securing the ribbon cable.
After the latch is released remove the ribbon cable and clear it from the board.
Step 5
- Remove the board itself by carefully pulling the board up then away from the rest of the computer.
Remove the board itself by carefully pulling the board up then away from the rest of the computer.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Wyatt Scott
Member since: 11/01/2018
136 Reputation
1 Guide authored
Badges:
3
Team
IUPUI, Team S2-G3, Harley Fall 2018
Member of IUPUI, Team S2-G3, Harley Fall 2018
IUPUI-HARLEY-F18S2G3
3 Members
2 Guides authored
