Asus Transformer Book T100Tam C1 Usb Input Replacement Repair Guide

Difficulty

Difficult

Steps

Time Required

                          10 minutes

Sections

USB Input
10 steps

Flags

BackAsus Transformer Book T100TAM-C1
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              USB Input

Remove the tablet portion of the device from the keyboard by pushing on the silver button located at the base of the tablet and lifting up on the tablet.

Remove the tablet portion of the device from the keyboard by pushing on the silver button located at the base of the tablet and lifting up on the tablet.

1024

Step 2

Use the plastic opening tool to remove both of the top corner pads.

Use the plastic opening tool to remove both of the top corner pads.

Step 3

Remove two 5mm Phillips #0 screws on the top corners.
Remove four 2.5mm Phillips #0 screws on the top corners.

Remove two 5mm Phillips #0 screws on the top corners.

Remove four 2.5mm Phillips #0 screws on the top corners.

Step 4

Use the pick and pry apart the keyboard.

Use the pick and pry apart the keyboard.

Step 5

Use the size 0 Phillips screwdriver and remove the nine screws from the back panel. The four you need to remove across the top are 3mm and the four across the bottom are 2.5mm.
The screw in the top right, shown where the screwdriver is, is a 5mm screw.

Use the size 0 Phillips screwdriver and remove the nine screws from the back panel. The four you need to remove across the top are 3mm and the four across the bottom are 2.5mm.

The screw in the top right, shown where the screwdriver is, is a 5mm screw.

Step 6

Use tweezers and remove the black tape from the back panel.

Use tweezers and remove the black tape from the back panel.

Step 7

Remove the metal back panel from the keyboard.

Remove the metal back panel from the keyboard.

Step 8

Flip the connectors back to release the wires
Take the white tab and gently pull it to the right in order to release the connecting piece.

Flip the connectors back to release the wires

Take the white tab and gently pull it to the right in order to release the connecting piece.

Step 9

Remove the screw from the green plate.
Once all of the screws are out, remove the plate.

Remove the screw from the green plate.

Once all of the screws are out, remove the plate.

Step 10

Place soldering tool on each of the four connecting pieces in the corner until each becomes unattached.
Remove old USB input and replace with the new one.

Place soldering tool on each of the four connecting pieces in the corner until each becomes unattached.

Remove old USB input and replace with the new one.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Brody Moore

Member since: 09/06/2018

807 Reputation

                                      7 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Ohio State, Team S1-G2, Whitney Fall 2018                        

                                                  Member of Ohio State, Team S1-G2, Whitney Fall 2018 



                    OSU-WHITNEY-F18S1G2                     


                                            2 Members                     


                                            7 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team