Asus Transformer Book T100Tar Trackpad Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 - 15 minutes

Sections

Trackpad
6 steps

Flags

BackAsus Transformer Book T100TAR
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Trackpad

Detach and separate the screen from the keyboard by pressing the silver release button at the base of the tablet.

Detach and separate the screen from the keyboard by pressing the silver release button at the base of the tablet.

1024

Step 2

Using a Phillips #0 screwdriver, unscrew six 4mm screws from the rear cover of the keyboard.
The rest of the screws for this guide will be Phillips #0 head screws.
Use the metal spudger to remove the rubber feet nearest to the top of the keyboard, where the connecting dock to the screen is. There are two 6mm screws under these rubber feet.

Using a Phillips #0 screwdriver, unscrew six 4mm screws from the rear cover of the keyboard.

The rest of the screws for this guide will be Phillips #0 head screws.

Use the metal spudger to remove the rubber feet nearest to the top of the keyboard, where the connecting dock to the screen is. There are two 6mm screws under these rubber feet.

Step 3

Take the metal spudger and insert it into the seam of the rear cover casing and gently pry upwards.
If done correctly, you should feel the clips release.
Do not force the clips to release. This will cause them to break, and if broken, the screen will become loose. Open the rear cover gently and with caution.

Take the metal spudger and insert it into the seam of the rear cover casing and gently pry upwards.

If done correctly, you should feel the clips release.

Do not force the clips to release. This will cause them to break, and if broken, the screen will become loose. Open the rear cover gently and with caution.

Step 4

Unscrew the screws on the base plate of the keyboard dock. There should be four 4mm screws along the bottom and four 6mm screws along the top, apart from a single 4mm screw (annotated in orange)

Unscrew the screws on the base plate of the keyboard dock. There should be four 4mm screws along the bottom and four 6mm screws along the top, apart from a single 4mm screw (annotated in orange)

Step 5

Very carefully remove the black tape holding the metal plate in place.
This tape is very sticky, so you might want to use tweezers to get it loose before peeling it off.

Very carefully remove the black tape holding the metal plate in place.

This tape is very sticky, so you might want to use tweezers to get it loose before peeling it off.

Step 6

Unscrew three 4mm screws holding the trackpad in place and remove the trackpad.

Unscrew three 4mm screws holding the trackpad in place and remove the trackpad.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Alyssa Ballesteros

Member since: 09/07/2016

683 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       USF Tampa, Team 6-1, Remmell Fall 2016                        

                                                  Member of USF Tampa, Team 6-1, Remmell Fall 2016 



                    USFT-REMMELL-F16S6G1                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team