Difficulty
Moderate
Steps
9
Time Required
10 - 15 minutes
Sections
3
- Battery
- 5 steps
- WiFi Card
- 2 steps
- Screen
- 2 steps
Flags
1
Incorrect Tools
Help make this guide better by using the correct tools in images and/or text.
BackAsus V500CA-DB51T
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Remove the following ten screws securing the lower case to the upper case:
- The top left and right corners have .7 cm screws.
- The two top-middle and four bottom are .4 cm screws.
- The middle left and right are .8 cm screws.
- Remove the screws using the Phillips #00 screwdriver.
Remove the following ten screws securing the lower case to the upper case:
The top left and right corners have .7 cm screws.
The two top-middle and four bottom are .4 cm screws.
The middle left and right are .8 cm screws.
Remove the screws using the Phillips #00 screwdriver.
1024
Step 2
- Wedge your fingers between the upper case and the lower case.
- Gently pull the lower case away from the upper case.
- Remove the lower case and set it aside.
Wedge your fingers between the upper case and the lower case.
Gently pull the lower case away from the upper case.
Remove the lower case and set it aside.
Step 3
- Use the flat end of the blue plastic opening tool to lift the battery connector up out of its socket on the motherboard.
Use the flat end of the blue plastic opening tool to lift the battery connector up out of its socket on the motherboard.
Step 4
- Remove the tri-point screws that secure the battery to the casing.
- All screws securing the battery in place are .5 cm tri-point screws.
Remove the tri-point screws that secure the battery to the casing.
All screws securing the battery in place are .5 cm tri-point screws.
Step 5
- Use the opening tool to pop up the battery away from the casing.
Use the opening tool to pop up the battery away from the casing.
Step 6
WiFi Card
- Locate the section of the device that houses the WiFi Card.
- This should be a white, square-shaped object located just above the left end of the battery.
Locate the section of the device that houses the WiFi Card.
This should be a white, square-shaped object located just above the left end of the battery.
Step 7
- Disconnect the black and white wires that are connected to the WiFi card by gently pulling them upward with a pair of tweezers.
- Using the tweezers, gently pull the WiFi card out away from yourself.
- If you try pulling up you could cause damage, so be sure to slowly and gently pull the card away from yourself.
Disconnect the black and white wires that are connected to the WiFi card by gently pulling them upward with a pair of tweezers.
Using the tweezers, gently pull the WiFi card out away from yourself.
If you try pulling up you could cause damage, so be sure to slowly and gently pull the card away from yourself.
Step 8
Screen
- Gently remove the ribbon cable using tweezers.
- Using the Phillips #00 screwdriver remove the six .4 cm screws from the screen brackets.
Gently remove the ribbon cable using tweezers.
Using the Phillips #00 screwdriver remove the six .4 cm screws from the screen brackets.
Step 9
- Slowly lift up on the main case of the laptop.
- Gently pull the laptop from the screen when it is perpendicular with the screen.
Slowly lift up on the main case of the laptop.
Gently pull the laptop from the screen when it is perpendicular with the screen.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Galen P Garofalo
Member since: 10/17/2017
664 Reputation
6 Guides authored
Badges:
10
+7 more badges
Team
UMass Dartmouth, Team S6-G2, Rockett Fall 2017
Member of UMass Dartmouth, Team S6-G2, Rockett Fall 2017
UMASSD-ROCKETT-F17S6G2
3 Members
6 Guides authored
