Difficulty

Difficult

Steps

5

Time Required

                          25 - 50 minutes

Sections

1

  • LCD Assembly
  • 5 steps

Flags

2

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

  • BackAsus VivoBook Flip 14 TP410U

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              LCD Assembly
  • Turn off the power and disconnected the AC cable from the laptop.

Turn off the power and disconnected the AC cable from the laptop.

1024

Step 2

  • Remove the rubber covers for the two screws located at the bottom of the screen.
  • Use a Phillips #00 screwdriver to remove the two 6.4 mm screws outlined in the image.

Remove the rubber covers for the two screws located at the bottom of the screen.

Use a Phillips #00 screwdriver to remove the two 6.4 mm screws outlined in the image.

Step 3

  • Excessive force may cause damage to connections.
  • Rotate the screen 360 degrees for ease of access.
  • Place the opening tool at the corner of where the screen meets the base of the laptop.
  • Pry open the screen along the edge until it is completely off the front cover.
  • Disconnect each appropriate connector while opening up the laptop.

Excessive force may cause damage to connections.

Rotate the screen 360 degrees for ease of access.

Place the opening tool at the corner of where the screen meets the base of the laptop.

Pry open the screen along the edge until it is completely off the front cover.

Disconnect each appropriate connector while opening up the laptop.

Step 4

  • Excessive force should avoided since damage may accrue.
  • Remove the cable that connects to the touch display, front camera, and motherboard.
  • Remove each piece of tape that holds down each cable.

Excessive force should avoided since damage may accrue.

Remove the cable that connects to the touch display, front camera, and motherboard.

Remove each piece of tape that holds down each cable.

Step 5

  • Have the new LCD display fully unboxed and ready to be used.
  • Remove the old LCD display.
  • The touch screen sensor is extremely fragile, make sure to not put excessive force on the cable while assembling.

Have the new LCD display fully unboxed and ready to be used.

Remove the old LCD display.

The touch screen sensor is extremely fragile, make sure to not put excessive force on the cable while assembling.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Dominic Bento

Member since: 03/22/2022

284 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge