Difficulty

Moderate

Steps

7

Time Required

                          10 - 15 minutes

Sections

2

  • Keyboard Panel
  • 3 steps
  • Battery
  • 4 steps

Flags

0

  • BackASUS VivoBook Flip TP501U

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Keyboard Panel
  • Open the laptop until it is flat and lay it screen down.
  • Remove eight 9.6mm Phillips #00 screws from the bottom of the laptop.
  • Remove two 4.8mm Phillips from the corners of the device.

Open the laptop until it is flat and lay it screen down.

Remove eight 9.6mm Phillips #00 screws from the bottom of the laptop.

Remove two 4.8mm Phillips from the corners of the device.

1024

Step 2

  • Turn the device face up.
  • Use the plastic Opening Pick to separate the keyboard panel from the chassis that was just unscrewed.
  • Pull the panel away from the chassis CAREFULLY, as there are ribbon cables attached between the keyboard and internal electronics.

Turn the device face up.

Use the plastic Opening Pick to separate the keyboard panel from the chassis that was just unscrewed.

Pull the panel away from the chassis CAREFULLY, as there are ribbon cables attached between the keyboard and internal electronics.

Step 3

  • With the keyboard panel pulled up, detach the two ribbon cables from the motherboard using the blue tabs on the cables.
  • Remove the keyboard panel completely.

With the keyboard panel pulled up, detach the two ribbon cables from the motherboard using the blue tabs on the cables.

Remove the keyboard panel completely.

Step 4

              Battery
  • Remove the white ribbon cable shown by pulling on the blue tab.

Remove the white ribbon cable shown by pulling on the blue tab.

Step 5

  • Remove the black cable found beneath the white ribbon cable that you just removed.

Remove the black cable found beneath the white ribbon cable that you just removed.

Step 6

  • Disconnect the battery from the motherboard by unplugging the wire bundle shown.

Disconnect the battery from the motherboard by unplugging the wire bundle shown.

Step 7

  • Unscrew the 3/16 inch long screw that holds the battery to the chassis using a #00 Phillips Screwdriver.
  • Lift the battery from the chassis.

Unscrew the 3/16 inch long screw that holds the battery to the chassis using a #00 Phillips Screwdriver.

Lift the battery from the chassis.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Madeline Arnold

Member since: 01/14/2020

109 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Embry-Riddle Aeronautical University, Team S1-G1, Cromer Twal Spring 2020                        

                                                  Member of Embry-Riddle Aeronautical University, Team S1-G1, Cromer Twal Spring 2020 



                    ERAU-CROMER TWAL-S20S1G1                     


                                            4 Members                     


                                            6 Guides authored