Difficulty

Moderate

Steps

10

Time Required

                          25 minutes

Sections

3

  • Battery
  • 5 steps
  • Fan
  • 4 steps
  • Thermal Paste
  • 1 step

Flags

0

  • BackAsus VivoBook Q200E-BHI3T45

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Use a Phillips 0 screwdriver to remove nine Phillips screws from the back of the laptop (four 7mm from the top hinge, four 5mm from the bottom hinge, and one 10mm screw from the center).

Use a Phillips 0 screwdriver to remove nine Phillips screws from the back of the laptop (four 7mm from the top hinge, four 5mm from the bottom hinge, and one 10mm screw from the center).

1024

Step 2

  • Use a plastic opening tool to pry the back panel off.

Use a plastic opening tool to pry the back panel off.

Step 3

  • Use a Phillips 0 screwdriver to remove the eight 5mm Phillips screws holding the battery in place.

Use a Phillips 0 screwdriver to remove the eight 5mm Phillips screws holding the battery in place.

Step 4

  • Remove the ribbon cable with a pair of tweezers.

Remove the ribbon cable with a pair of tweezers.

Step 5

  • Lift and remove the battery.

Lift and remove the battery.

Step 6

              Fan
  • Gently peel off the tape from the fan.

Gently peel off the tape from the fan.

Step 7

  • Remove five 5mm screws using a Phillips 0 screwdriver.
  • Remove the two 2mm screws with a Phillips 000 screwdriver.

Remove five 5mm screws using a Phillips 0 screwdriver.

Remove the two 2mm screws with a Phillips 000 screwdriver.

Step 8

  • Disconnect the fan’s power cable by pulling upward on the pin connector with a pair of tweezers.

Disconnect the fan’s power cable by pulling upward on the pin connector with a pair of tweezers.

Step 9

  • Grab the sides of the fan assembly and remove it by lifting upwards.

Grab the sides of the fan assembly and remove it by lifting upwards.

Step 10

              Thermal Paste
  • Use isopropyl alcohol and a cotton ball to clean thermal paste off the CPU and back of the heatsink.
  • Apply a drop of thermal paste on the CPU.
  • Carefully place heatsink/fan assembly back.

Use isopropyl alcohol and a cotton ball to clean thermal paste off the CPU and back of the heatsink.

Apply a drop of thermal paste on the CPU.

Carefully place heatsink/fan assembly back.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Bryann Tan

Member since: 09/25/2016

838 Reputation

                                      6 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       USF Tampa, Team 16-2, Eyestone Fall 2016                        

                                                  Member of USF Tampa, Team 16-2, Eyestone Fall 2016 



                    USFT-EYESTONE-F16S16G2                     


                                            3 Members                     


                                            6 Guides authored