Difficulty
Moderate
Steps
8
Time Required
15 minutes
Sections
2
- Battery
- 5 steps
- WLAN (Wireless Chip)
- 3 steps
Flags
0
BackAsus VivoBook Q200E-BHI3T45
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Use a Phillips 0 screwdriver to remove nine Phillips screws from the back of the laptop (four 7mm from the top hinge, four 5mm from the bottom hinge, and one 10mm screw from the center).
Use a Phillips 0 screwdriver to remove nine Phillips screws from the back of the laptop (four 7mm from the top hinge, four 5mm from the bottom hinge, and one 10mm screw from the center).
1024
Step 2
- Use a plastic opening tool to pry the back panel off.
Use a plastic opening tool to pry the back panel off.
Step 3
- Use a Phillips 0 screwdriver to remove the eight 5mm Phillips screws holding the battery in place.
Use a Phillips 0 screwdriver to remove the eight 5mm Phillips screws holding the battery in place.
Step 4
- Remove the ribbon cable with a pair of tweezers.
Remove the ribbon cable with a pair of tweezers.
Step 5
- Lift and remove the battery.
Lift and remove the battery.
Step 6
WLAN (Wireless Chip)
- Remove one 5mm screw using a PH0 Philips screwdriver.
Remove one 5mm screw using a PH0 Philips screwdriver.
Step 7
- Remove the cable by lifting upwards with a pair of tweezers.
Remove the cable by lifting upwards with a pair of tweezers.
Step 8
- Remove the WLAN chip by pulling out parallel to the surface.
Remove the WLAN chip by pulling out parallel to the surface.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Bryann Tan
Member since: 09/25/2016
838 Reputation
6 Guides authored
Badges:
14
+11 more badges
Team
USF Tampa, Team 16-2, Eyestone Fall 2016
Member of USF Tampa, Team 16-2, Eyestone Fall 2016
USFT-EYESTONE-F16S16G2
3 Members
6 Guides authored
