Asus Vivobook Q301La Bhi5T02 Screen Replacement Repair Guide

Difficulty

Difficult

Steps

Time Required

                          35 - 45 minutes

Sections

Back Cover
4 steps
Screen
12 steps

Flags

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

BackAsus Vivobook Q301LA-BHI5T02
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Cover

Make sure the computer is turned off.
Flip the device over so that the back cover is facing you.

Make sure the computer is turned off.

Flip the device over so that the back cover is facing you.

1024

Step 2

Remove the four 5mm Phillips #1 screws from the top of the laptop.
Remove the two 6mm Phillips #1 screws from the sides of the laptop.
Remove the four 2mm Phillips #1 screws from the bottom of the laptop.

Remove the four 5mm Phillips #1 screws from the top of the laptop.

Remove the two 6mm Phillips #1 screws from the sides of the laptop.

Remove the four 2mm Phillips #1 screws from the bottom of the laptop.

Step 3

Use a plastic opening tool to gently pry the bottom of the laptop up. Slowly slide it along the edges, twisting it every so often to pop the bottom of the laptop out of the clips holding it in place.

Use a plastic opening tool to gently pry the bottom of the laptop up. Slowly slide it along the edges, twisting it every so often to pop the bottom of the laptop out of the clips holding it in place.

Step 4

Lift off the cover and remove the back cover from the device.

Lift off the cover and remove the back cover from the device.

Step 5

              Screen

Unplug the screen connector from the motherboard.

Unplug the screen connector from the motherboard.

Step 6

Using a Phillips #1 Screwdriver unscrew the four 4 mm screws holding the screen holder onto the motherboard.

Using a Phillips #1 Screwdriver unscrew the four 4 mm screws holding the screen holder onto the motherboard.

Step 7

Remove the two cables connecting to the wifi card.

Remove the two cables connecting to the wifi card.

Step 8

Remove the screen holder from the rest of the laptop.
Make sure when removing screen cover lift bottom of the laptop to about a 45° degree angle when removing it.

Remove the screen holder from the rest of the laptop.

Make sure when removing screen cover lift bottom of the laptop to about a 45° degree angle when removing it.

Step 9

Remove the bottom of the laptop from the screen.

Remove the bottom of the laptop from the screen.

Step 10

Remove the hinge cover by gently pulling to the right then upwards.

Remove the hinge cover by gently pulling to the right then upwards.

Step 11

Using a Phillips #1 Screwdriver unscrew the six 3 mm black screws and the three 2 mm copper screws that are keeping the screen in place.
Keep track of what screws go where.

Using a Phillips #1 Screwdriver unscrew the six 3 mm black screws and the three 2 mm copper screws that are keeping the screen in place.

Keep track of what screws go where.

Step 12

Push screen downwards then pull top of screen upwards and remove the screen.

Push screen downwards then pull top of screen upwards and remove the screen.

Step 13

Using a Phillips #1 Screwdriver Unscrew the four 2 mm screws holding the screen onto the screen cover.
Use the PH0 bit screwdriver to unscrew the screws.

Using a Phillips #1 Screwdriver Unscrew the four 2 mm screws holding the screen onto the screen cover.

Use the PH0 bit screwdriver to unscrew the screws.

Step 14

Use a sharp object to remove tape from the back of the screen.
Careful when cutting the tape off, you can accidentally cut a wire

Use a sharp object to remove tape from the back of the screen.

Careful when cutting the tape off, you can accidentally cut a wire

Step 15

Unplug the screen from the screen holder.
Don’t pull the cable too hard or it can damage the connection.

Unplug the screen from the screen holder.

Don’t pull the cable too hard or it can damage the connection.

Step 16

Take the screen off of the screen holder.

Take the screen off of the screen holder.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 3 other contributors

                    Jorge Villarreal

Member since: 10/02/2017

397 Reputation

                                      3 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       USF Tampa, Team S10-G3, Thompson Fall 2017                        

                                                  Member of USF Tampa, Team S10-G3, Thompson Fall 2017 



                    USFT-THOMPSON-F17S10G3                     


                                            4 Members                     


                                            6 Guides authored

Markup Mishap#

Introduction#

What you need#

Team#

Markup Mishap

Introduction

What you need

Team