Asus Vivobook S400C Led Board Replacement Repair Guide

Difficulty

Easy

Steps

6

Time Required

Suggest a time??

Sections

2

• Battery Disconnect
• 3 steps
• LED Board
• 3 steps

Flags

1

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackASUS VivoBook S400C

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Note that the battery has been removed for the purpose of visual clarity in this guide, but it is not necessary in order to replace the LED board. Doing so does make removing the ribbon cable slightly easier.

What you need

Step 1

              Remove the Bottom Cover               

• Flip the device over and remove the ten 5.7 mm screws with a Phillips #0 screwdriver.

Flip the device over and remove the ten 5.7 mm screws with a Phillips #0 screwdriver.

1024

Step 2

• Use a spudger or your fingers to go around and lift the edges and release the back panel.

Use a spudger or your fingers to go around and lift the edges and release the back panel.

Step 3

              Disconnect the Battery               

• Using a spudger, lift up the plug connecting the battery to the motherboard.

Using a spudger, lift up the plug connecting the battery to the motherboard.

Step 4

              LED Board               

• Disconnect the ribbon cable connecting the LED daughterboard and the motherboard by lifting the white tab on the LED side of the cable.

Disconnect the ribbon cable connecting the LED daughterboard and the motherboard by lifting the white tab on the LED side of the cable.

Step 5

• Pull out the ribbon cable on the LED side by pulling on the blue tab.

Pull out the ribbon cable on the LED side by pulling on the blue tab.

Step 6

• The LED board is held in place by a hook on the left end and a latch on the right.
• Press the latch with a spudger while lifting with a fingernail.
• Pull the LED board to the right to clear the left-hand hook.

The LED board is held in place by a hook on the left end and a latch on the right.

Press the latch with a spudger while lifting with a fingernail.

Pull the LED board to the right to clear the left-hand hook.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Jerry W                     

Member since: 03/21/2022

23,571 Reputation

                                      50 Guides authored                  



                       Badges:
                       39







                                                        +36 more badges