Asus Vivotab Note 8 Io Board Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          2 - 4 minutes            

Sections

2

• Back Panel
• 3 steps
• IO Board
• 3 steps

Flags

0

• BackASUS VivoTab Note 8

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Back Panel               

• Remove the pen and memory card if you have them; they may get in the way when you are opening the device.
• Pry open the edges of the cover using the plastic opening tool. The memory card slot is very useful for getting started.

Remove the pen and memory card if you have them; they may get in the way when you are opening the device.

Pry open the edges of the cover using the plastic opening tool. The memory card slot is very useful for getting started.

1024

Step 2

• Move the opening tool along the edges of the tablet and push up wherever you can. You may need to open up all of the sides to take the panel off.
• Pull apart the sides of the casing by hand.

Move the opening tool along the edges of the tablet and push up wherever you can. You may need to open up all of the sides to take the panel off.

Pull apart the sides of the casing by hand.

Step 3

• After pulling the panel off, put it to the side.

After pulling the panel off, put it to the side.

Step 4

              IO Board               

• After removing the back panel, you will see the IO Board under another removable plastic piece.

After removing the back panel, you will see the IO Board under another removable plastic piece.

Step 5

• Unscrew the two screws of the plastic piece, and lift it off.

Unscrew the two screws of the plastic piece, and lift it off.

Step 6

• Unscrew the screw holding down the IO Board.
• Pull out the ribbon (hold the ribbon with one hand and the board with the other, then pull) and remove the IO Board.

Unscrew the screw holding down the IO Board.

Pull out the ribbon (hold the ribbon with one hand and the board with the other, then pull) and remove the IO Board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Ryan Spencer                     

Member since: 09/21/2018

597 Reputation

                                      5 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       University of North Texas, Team S6-G7, Thompson Fall 2018                        

                                                  Member of University of North Texas, Team S6-G7, Thompson Fall 2018 



                    UNT-THOMPSON-F18S6G7                     


                                            3 Members                     


                                            5 Guides authored