Difficulty

Moderate

Steps

11

Time Required

                          10 - 20 minutes

Sections

2

  • Motherboard
  • 9 steps
  • Camera
  • 2 steps

Flags

0

  • BackAsus VivoTab Smart

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Motherboard
  • Power off the device before you begin disassembly.
  • Place the device face down on a flat surface.
  • Remove the back panel with the plastic opening tool by sliding the tool around the edge of the panel.

Power off the device before you begin disassembly.

Place the device face down on a flat surface.

Remove the back panel with the plastic opening tool by sliding the tool around the edge of the panel.

1024

Step 2

  • Unplug the ribbon that connects to the camera by pulling outward on it with tweezers.
  • Remove the silver plate that sits on top of the camera lens.

Unplug the ribbon that connects to the camera by pulling outward on it with tweezers.

Remove the silver plate that sits on top of the camera lens.

Step 3

  • Use tweezers to grab the speaker cable near the white plug and pull to disconnect it.

Use tweezers to grab the speaker cable near the white plug and pull to disconnect it.

Step 4

  • Gently pull outward on the ribbon to with tweezers to disconnect it.

Gently pull outward on the ribbon to with tweezers to disconnect it.

Step 5

  • Peel back the tape covering the ribbons.

Peel back the tape covering the ribbons.

Step 6

  • Unplug the 3 ribbons by pulling outward on them with a pair of tweezers.

Unplug the 3 ribbons by pulling outward on them with a pair of tweezers.

Step 7

  • Remove two 2.7 mm Phillips #00 screws holding down the pressure plate.
  • Use tweezers to lift back the battery connector, which is located directly under the pressure plate.

Remove two 2.7 mm Phillips #00 screws holding down the pressure plate.

Use tweezers to lift back the battery connector, which is located directly under the pressure plate.

Step 8

  • Remove seven 3.7 mm Phillips #00 screws.
  • Remove one 2.7 mm Phillips #00 screw.

Remove seven 3.7 mm Phillips #00 screws.

Remove one 2.7 mm Phillips #00 screw.

Step 9

  • Slide the tweezers under the motherboard and lift up to remove the motherboard.

Slide the tweezers under the motherboard and lift up to remove the motherboard.

Step 10

              Camera
  • Flip the motherboard over and lay it flat on a surface

Flip the motherboard over and lay it flat on a surface

Step 11

  • Use tweezers to gently lift and remove the camera from the motherboard.

Use tweezers to gently lift and remove the camera from the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 


                    Zach Hatten

Member since: 10/06/2016

548 Reputation

                                      4 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       USF Tampa, Team 2-4, Sullivan Fall 2016                        

                                                  Member of USF Tampa, Team 2-4, Sullivan Fall 2016 



                    USFT-SULLIVAN-F16S2G4                     


                                            4 Members                     


                                            5 Guides authored