Difficulty
Moderate
Steps
8
Time Required
10 minutes
Sections
2
- Keyboard
- 3 steps
- Motherboard and RAM
- 5 steps
Flags
0
BackAsus X200CA
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Keyboard
- Remove the 8 black 4.7mm screws securing the keyboard to the bottom cover.
- Remove the black 14.5mm screw from the center of the bottom cover.
Remove the 8 black 4.7mm screws securing the keyboard to the bottom cover.
Remove the black 14.5mm screw from the center of the bottom cover.
1024
Step 2
- Wedge a metal spudger between the keyboard and bottom cover and slide it around the perimeter until all edges separate.
Wedge a metal spudger between the keyboard and bottom cover and slide it around the perimeter until all edges separate.
Step 3
- Pull apart the keyboard and the bottom cover using your hands.
- The keyboard and trackpad cables are still connected to the mainboard via a ZIF connector. Carefully disconnect them before completely removing the keyboard to prevent damage to the board or cables.
Pull apart the keyboard and the bottom cover using your hands.
The keyboard and trackpad cables are still connected to the mainboard via a ZIF connector. Carefully disconnect them before completely removing the keyboard to prevent damage to the board or cables.
Step 4
Motherboard and RAM
- Remove the black plastic cover.
Remove the black plastic cover.
Step 5
- Remove the 10 black 4.7mm screws holding the motherboard/RAM in place using a Phillips #00 screwdriver.
Remove the 10 black 4.7mm screws holding the motherboard/RAM in place using a Phillips #00 screwdriver.
Step 6
- Use tweezers to separate the 2 sliding connectors and the ribbon cable connector.
Use tweezers to separate the 2 sliding connectors and the ribbon cable connector.
Step 7
- Use fingers to grab the black tape tab and pull back to disconnect the battery connector.
Use fingers to grab the black tape tab and pull back to disconnect the battery connector.
Step 8
- Lift the motherboard/RAM out from the frame.
Lift the motherboard/RAM out from the frame.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
7 other people completed this guide.
Author
with 3 other contributors
Jacqueline Collier
Member since: 10/09/2017
1,047 Reputation
5 Guides authored
Badges:
14
+11 more badges
Team
USF Tampa, Team S1-G2, Leahy Fall 2017
Member of USF Tampa, Team S1-G2, Leahy Fall 2017
USFT-LEAHY-F17S1G2
4 Members
5 Guides authored
