Difficulty
Moderate
Steps
7
Time Required
15 - 30 minutes
Sections
2
- Keyboard Assembly
- 2 steps
- Speaker
- 5 steps
Flags
0
BackAsus X200MA
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Remove the following six screws:
- Six 4 mm screws using a Phillips #0 screwdriver.
- Remove the following one screw:
- One 14 mm screw using a Phillips #0 screwdriver.
- The 14mm screw goes in the center.
Remove the following six screws:
Six 4 mm screws using a Phillips #0 screwdriver.
Remove the following one screw:
One 14 mm screw using a Phillips #0 screwdriver.
The 14mm screw goes in the center.
1024
Step 2
- Use a plastic or metal spudger to separate the keyboard from the back panel and lift the keyboard out of place.
Use a plastic or metal spudger to separate the keyboard from the back panel and lift the keyboard out of place.
Step 3
Speaker
- Disconnect the gold cap that connects to a black wire using the metal spudger.
Disconnect the gold cap that connects to a black wire using the metal spudger.
Step 4
- Remove the plastic component from the clip by gently pulling it back.
Remove the plastic component from the clip by gently pulling it back.
Step 5
- Use the tweezers to free the speaker from the plastic clips.
- Use a finger to lift the speaker and break the bond between the adhesive on the base plate and the speaker.
Use the tweezers to free the speaker from the plastic clips.
Use a finger to lift the speaker and break the bond between the adhesive on the base plate and the speaker.
Step 6
- Use the tweezers to carefully lift the wires from the plastic clips.
Use the tweezers to carefully lift the wires from the plastic clips.
Step 7
- Use the metal tweezers to free the speaker from the plastic clips.
- Use the metal spudger to break the bond between the base plate adhesive and the speaker.
- Lift the speakers and remove them from the base plate.
Use the metal tweezers to free the speaker from the plastic clips.
Use the metal spudger to break the bond between the base plate adhesive and the speaker.
Lift the speakers and remove them from the base plate.
To reassemble your device, follow these instructions in reverse [#|order].
Cancel: I did not complete this guide.
Author
with 3 other contributors
Alli Krininger
Member since: 11/11/2019
391 Reputation
3 Guides authored
Badges:
7
+4 more badges
Team
IUPUI, Team S2-G4, Stella Fall 2019
Member of IUPUI, Team S2-G4, Stella Fall 2019
IUPUI-STELLA-F19S2G4
4 Members
3 Guides authored
