Difficulty

Moderate

Steps

5

Time Required

                          15 - 25 minutes

Sections

2

  • Battery
  • 3 steps
  • Fan
  • 2 steps

Flags

0

  • BackASUS X553SA-BHCLN10

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Turn over the laptop on the back panel.
  • Use the Phillips #0 screwdriver to unscrew all ten screws visible on the back panel. There should be a total of ten screws: (4) four 5.5mm screws and (6) six 10.5mm screws.

Turn over the laptop on the back panel.

Use the Phillips #0 screwdriver to unscrew all ten screws visible on the back panel. There should be a total of ten screws: (4) four 5.5mm screws and (6) six 10.5mm screws.

1024

Step 2

  • Turn over the laptop with the keyboard facing upwards.
  • Using a small prying or opening tool, stick the prying tool under the edge of the laptop.

Turn over the laptop with the keyboard facing upwards.

Using a small prying or opening tool, stick the prying tool under the edge of the laptop.

Step 3

  • After the laptop is completely pried open carefully remove the keyboard from the laptop.
  • There are two small keyboard cables connecting the keyboard to the laptop. Carefully remove these by popping up the white clips holding them in place and slide the connector out.

After the laptop is completely pried open carefully remove the keyboard from the laptop.

There are two small keyboard cables connecting the keyboard to the laptop. Carefully remove these by popping up the white clips holding them in place and slide the connector out.

Step 4

              Fan
  • Remove the three 5.5mm screws shown in the picture using the Phillips #0 screwdriver.
  • Carefully push the white connector out of the slot.
  • After removing the black electrical tape hold on to the side of the fan and lightly pull on the wire to remove the fan.

Remove the three 5.5mm screws shown in the picture using the Phillips #0 screwdriver.

Carefully push the white connector out of the slot.

After removing the black electrical tape hold on to the side of the fan and lightly pull on the wire to remove the fan.

Step 5

  • Remove the fan completely . attach electrical tape on the new fan for replacement.

Remove the fan completely . attach electrical tape on the new fan for replacement.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Edmund Lee

Member since: 09/26/2017

473 Reputation

                                      4 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       USF Tampa, Team S13-G3, Boczar Fall 2017                        

                                                  Member of USF Tampa, Team S13-G3, Boczar Fall 2017 



                    USFT-BOCZAR-F17S13G3                     


                                            5 Members                     


                                            5 Guides authored