Difficulty
Moderate
Steps
9
Time Required
15 minutes
Sections
1
- Web Cam
- 9 steps
Flags
0
BackAsus X751MA-DH01TQ
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Web Cam
- Turn the laptop upside down and locate the ten screws that hold the plate cover.
- Remove all ten screws using a 00 Phillips head screwdriver.
Turn the laptop upside down and locate the ten screws that hold the plate cover.
Remove all ten screws using a 00 Phillips head screwdriver.
1024
Step 2
- Using the plastic opening tool, pry the keyboard off of the base of the laptop.
- Lift up and remove the keyboard.
Using the plastic opening tool, pry the keyboard off of the base of the laptop.
Lift up and remove the keyboard.
Step 3
- Remove eight 4.4 Phillips #00 screws attached to the hinge.
- Hold the screen so it wont fall over.
Remove eight 4.4 Phillips #00 screws attached to the hinge.
Hold the screen so it wont fall over.
Step 4
- Remove the stickers from the bottom left and right corners of the screen.
- Use a 00 Phillips head screw driver to remove the four screws.
Remove the stickers from the bottom left and right corners of the screen.
Use a 00 Phillips head screw driver to remove the four screws.
Step 5
- Use the plastic opening tool to take the screen apart.
Use the plastic opening tool to take the screen apart.
Step 6
- Remove the two 4mm Phillips #00 screws attached to the webcam.
Remove the two 4mm Phillips #00 screws attached to the webcam.
Step 7
- Slowly pull up the webcam out of its slot, and begin to remove the wire.
Slowly pull up the webcam out of its slot, and begin to remove the wire.
Step 8
- Continue to unravel the wire and peel the webcam wire sticker off.
Continue to unravel the wire and peel the webcam wire sticker off.
Step 9
- Once the sticker is peeled off pull the plug holding the webcam into the circuit board and the webcam is now disconnected.
Once the sticker is peeled off pull the plug holding the webcam into the circuit board and the webcam is now disconnected.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Darren Kim
Member since: 09/18/2018
657 Reputation
3 Guides authored
Badges:
9
+6 more badges
Team
University of North Texas, Team S1-G1, Thomas Spring 2020
Member of University of North Texas, Team S1-G1, Thomas Spring 2020
UNT-THOMAS-S20S1G1
3 Members
3 Guides authored
