Asus Zenbook Ux21E Solid State Drive Replacement Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          7 - 10 minutes            

Sections

2

• Battery
• 4 steps
• Solid-State Drive
• 1 step

Flags

0

• BackAsus ZenBook UX21e

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

When removing the screw, try to remove the tape covering it.

What you need

Step 1

              Battery               

• Using a T4 Torx screwdriver, unscrew the ten screws lining the bottom cover. Then, proceed to remove the bottom cover by sliding it out parallel toward the back of the computer.
• There are two length of screws. Eight screws are 3mm and two are 5mm. The two 5mm screws always go into the two center holes along the back edge.

Using a T4 Torx screwdriver, unscrew the ten screws lining the bottom cover. Then, proceed to remove the bottom cover by sliding it out parallel toward the back of the computer.

There are two length of screws. Eight screws are 3mm and two are 5mm. The two 5mm screws always go into the two center holes along the back edge.

1024

Step 2

• Using an iFixit opening tool and your other hand, gently lift the connector up from the tape wrapped around the connector wires and pry the connector from the motherboard.

Using an iFixit opening tool and your other hand, gently lift the connector up from the tape wrapped around the connector wires and pry the connector from the motherboard.

Step 3

• Remove the battery by unscrewing the five 3mm screws using a Phillips #1 screwdriver.
• One at each corner and one in the center.

Remove the battery by unscrewing the five 3mm screws using a Phillips #1 screwdriver.

One at each corner and one in the center.

Step 4

• Lift the battery directly up and remove it from the device.

Lift the battery directly up and remove it from the device.

Step 5

              Solid-State Drive               

• Unscrew the single 3mm screw with a Phillips #1 screwdriver at the rightmost edge of the Hard Drive.
• Remove the Hard Drive by sliding it parallel to the motherboard.

Unscrew the single 3mm screw with a Phillips #1 screwdriver at the rightmost edge of the Hard Drive.

Remove the Hard Drive by sliding it parallel to the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 7 other contributors 

                    Zachary Eslick                     

Member since: 04/23/2018

738 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       Cal Poly, Team S22-G1, Maness Spring 2018                        

                                                  Member of Cal Poly, Team S22-G1, Maness Spring 2018 



                    CPSU-MANESS-S18S22G1                     


                                            3 Members                     


                                            5 Guides authored