Difficulty
Moderate
Steps
7
Time Required
10 - 15 minutes
Sections
2
- Battery
- 4 steps
- WiFi Card
- 3 steps
Flags
0
BackAsus ZenBook UX21e
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Make sure when you are disconnecting the small cables to keep them in their relative positions, as they can be pulled out from the resting area.
What you need
Step 1
Battery
- Using a T4 Torx screwdriver, unscrew the ten screws lining the bottom cover. Then, proceed to remove the bottom cover by sliding it out parallel toward the back of the computer.
- There are two length of screws. Eight screws are 3mm and two are 5mm. The two 5mm screws always go into the two center holes along the back edge.
Using a T4 Torx screwdriver, unscrew the ten screws lining the bottom cover. Then, proceed to remove the bottom cover by sliding it out parallel toward the back of the computer.
There are two length of screws. Eight screws are 3mm and two are 5mm. The two 5mm screws always go into the two center holes along the back edge.
1024
Step 2
- Using an iFixit opening tool and your other hand, gently lift the connector up from the tape wrapped around the connector wires and pry the connector from the motherboard.
Using an iFixit opening tool and your other hand, gently lift the connector up from the tape wrapped around the connector wires and pry the connector from the motherboard.
Step 3
- Remove the battery by unscrewing the five 3mm screws using a Phillips #1 screwdriver.
- One at each corner and one in the center.
Remove the battery by unscrewing the five 3mm screws using a Phillips #1 screwdriver.
One at each corner and one in the center.
Step 4
- Lift the battery directly up and remove it from the device.
Lift the battery directly up and remove it from the device.
Step 5
WiFi Card
- Remove black tape cover from WiFi Card by peeling it off.
Remove black tape cover from WiFi Card by peeling it off.
Step 6
- Lift up the black and white connecting cable. Move the cables out of way to clear space.
- An iFixit tool can be used to remove the cables but it is not necessary.
Lift up the black and white connecting cable. Move the cables out of way to clear space.
An iFixit tool can be used to remove the cables but it is not necessary.
Step 7
- Unscrew the single 3mm with a Phillips #1 screwdriver at the front end of the WiFi card slot.
- Remove the WiFi card by sliding the card parallel to the device toward the screen edge of the device. Once clear of the slot, lift up the WiFi card and remove it from the device.
Unscrew the single 3mm with a Phillips #1 screwdriver at the front end of the WiFi card slot.
Remove the WiFi card by sliding the card parallel to the device toward the screen edge of the device. Once clear of the slot, lift up the WiFi card and remove it from the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 5 other contributors
Zachary Eslick
Member since: 04/23/2018
738 Reputation
5 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team S22-G1, Maness Spring 2018
Member of Cal Poly, Team S22-G1, Maness Spring 2018
CPSU-MANESS-S18S22G1
3 Members
5 Guides authored