Asus Zenbook Ux303L Cooling Fan Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          35 minutes            

Sections

1

• Cooling Fan
• 6 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

• BackAsus Zenbook UX303L

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Should you need to replace the cooling fan on this device, this guide will provide you with step-by-step instructions on how to properly do so.

We also suggest working somewhere underneath bright lighting, so that you can clearly see the repairs you are making.

Use this guide to properly replace the cooling fan on your Asus Zenbook UX303L.

What you need

Step 1

              Cooling Fan               

• Make sure the device is turned off and disconnected from the battery charger.

Make sure the device is turned off and disconnected from the battery charger.

1024

Step 2

• Remove the rubber pads closer to the air vents and remove the two screws using a P0 screwdriver.
• Remove all the nine screws from the bottom of the device using a T5 screwdriver.
• Carefully remove the bottom cover.

Remove the rubber pads closer to the air vents and remove the two screws using a P0 screwdriver.

Remove all the nine screws from the bottom of the device using a T5 screwdriver.

Carefully remove the bottom cover.

Step 3

• Pull on the black flap to lift the LVDS cable next to the cooling fan.

Pull on the black flap to lift the LVDS cable next to the cooling fan.

Step 4

• Remove the three screws from the hinges using a PH-1 screwdriver.
• Open the device at a 90 degree angle to free the hinges.

Remove the three screws from the hinges using a PH-1 screwdriver.

Open the device at a 90 degree angle to free the hinges.

Step 5

• Remove the screws attached to the cooling fan with a PH-1 screwdriver.
• Disconnect the wire attaching the cooling fan to the motherboard.

Remove the screws attached to the cooling fan with a PH-1 screwdriver.

Disconnect the wire attaching the cooling fan to the motherboard.

Step 6

• Gently lift and slide the cooling fan out.

Gently lift and slide the cooling fan out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.                                             

Author

                                      with 8 other contributors 

                    Bianka Castaneda                     

Member since: 10/13/2015

469 Reputation

                                      2 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges                           

Team

                       Sam Houston State, Team 1-3, Blackburne Fall 2015                        

                                                  Member of Sam Houston State, Team 1-3, Blackburne Fall 2015 



                    SHSU-BLACKBURNE-F15S1G3                     


                                            3 Members                     


                                            4 Guides authored                     

Sean Gerald Wong - Nov 16, 2017

Reply

After the 6 step Would i then just remove the dust on the cooling fan and reassemble after that? or replace the fan as a whole

mhyson - Jul 13, 2018

Reply

I wish you guys had included the part number for the cooling fan.