Difficulty

Moderate

Steps

6

Time Required

                          20 - 30 minutes

Sections

1

  • Speaker
  • 6 steps

Flags

0

  • BackASUS ZenFone 2 Laser

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Before following this guide, ensure you have the correct Zenfone 2 Laser model as listed here as other variants may not have the same procedure.

Step 1 requires a complete shut down, if the display is damaged and using the normal shutdown procedure (as shown in step 1 of the guide) is not possible, use the following step 2 and step 3 procedure to manually shut down the phone. Although not necessarily recommended to perform an emergency shutdown, this is essential to prevent the possibility of short circuiting.

Short circuiting is when a material (tool or something) creates a connection between two electrical components with lower resistance that causes damage.

What you need

Step 1

              Speaker
  • Press and hold the power button until the menu appears with the option to power off.
  • If the power button is not working, proceed to step 2 and 3 to manually force shutdown the device.

Press and hold the power button until the menu appears with the option to power off.

If the power button is not working, proceed to step 2 and 3 to manually force shutdown the device.

1024

Step 2

  • On the lower right-hand side of the device, locate the notch and insert your finger nail to loosen the rear panel.
  • Continue to slide your finger around the seam to completely remove the rear cover.

On the lower right-hand side of the device, locate the notch and insert your finger nail to loosen the rear panel.

Continue to slide your finger around the seam to completely remove the rear cover.

Step 3

  • Remove the sim card(s) and microSD card if installed.
  • Using your fingernail or spudger, remove the battery from the phone.

Remove the sim card(s) and microSD card if installed.

Using your fingernail or spudger, remove the battery from the phone.

Step 4

  • Unscrew and remove the ten 2.5mm Phillips #00 screws.
  • Unscrew and remove the two 5.5mm Phillips #00 screws.

Unscrew and remove the ten 2.5mm Phillips #00 screws.

Unscrew and remove the two 5.5mm Phillips #00 screws.

Step 5

  • Grab the lower portion of the frame and lift up to remove it.
  • If the gasket around the camera lens falls out, simply put it back around the camera.

Grab the lower portion of the frame and lift up to remove it.

If the gasket around the camera lens falls out, simply put it back around the camera.

Step 6

  • Use a spudger or other tool to gently lift up one side of the speaker. Continue lifting until the speaker is detached from the phone.
  • Ensure correct alignment of the speaker contacts to the pin on the circuit board.

Use a spudger or other tool to gently lift up one side of the speaker. Continue lifting until the speaker is detached from the phone.

Ensure correct alignment of the speaker contacts to the pin on the circuit board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Ang Heng

Member since: 01/17/2022

133 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       York University, Team 2-23, O'Regan Winter 2022                        

                                                  Member of York University, Team 2-23, O'Regan Winter 2022 



                    YORK-O'REGAN-W22S2G23                     


                                            1 Member                     


                                            1 Guide authored