Difficulty
Easy
Steps
2
Time Required
5 - 15 minutes
Sections
1
- Difficulty Button
- 2 steps
Flags
0
BackAtari Flashback 2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Difficulty Button
- Using the screwdriver and the PH1 bit, unscrew the five 10.0 mm screws on the bottom of the console.
- One screw is under the main sticker in the middle of the console.
Using the screwdriver and the PH1 bit, unscrew the five 10.0 mm screws on the bottom of the console.
One screw is under the main sticker in the middle of the console.
1024
Step 2
- Unscrew the two 10.0 mm Phillips #1 screws, and gently pull back the green circuit board.
- Remove gently. The circuit board is connected by wire to the board. Removing the cable from the console case may allow more slack.
- The button springs may be under compression.
Unscrew the two 10.0 mm Phillips #1 screws, and gently pull back the green circuit board.
Remove gently. The circuit board is connected by wire to the board. Removing the cable from the console case may allow more slack.
The button springs may be under compression.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Aaron Ramadan
Member since: 09/17/2018
135 Reputation
1 Guide authored
Badges:
3
Team
Washington State, Team S1-G2, Hope Fall 2018
Member of Washington State, Team S1-G2, Hope Fall 2018
WSU-HOPE-F18S1G2
4 Members
11 Guides authored
