Difficulty

Moderate

Steps

7

Time Required

                          30 minutes

Sections

3

  • Battery
  • 2 steps
  • Motherboard
  • 3 steps
  • Keypad/Plastic Display Screen
  • 2 steps

Flags

0

  • BackATT EL52300

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Find the bump where the battery cover meets the phone. Put your thumb here, and push and slide the cover down.

Find the bump where the battery cover meets the phone. Put your thumb here, and push and slide the cover down.

1024

Step 2

  • Unplug the battery by squeezing your hands on the small white plug and lifting it up.
  • Do not pull on the wire itself because you might damage the wire!
  • The battery is now detached and ready to be removed by lifting it out.

Unplug the battery by squeezing your hands on the small white plug and lifting it up.

Do not pull on the wire itself because you might damage the wire!

The battery is now detached and ready to be removed by lifting it out.

Step 3

              Motherboard
  • Remove the two 3.75 mm screws with a PH1 screwdriver.

Remove the two 3.75 mm screws with a PH1 screwdriver.

Step 4

  • Use a plastic opening tool to remove the handset case.
  • Be careful to not lift the case too far as the ringer cable is attached to the case.

Use a plastic opening tool to remove the handset case.

Be careful to not lift the case too far as the ringer cable is attached to the case.

Step 5

  • Remove the two 3.65 mm screws on the motherboard with a PH1 screwdriver.
  • Use an anti-static wrist strap to prevent damage to the motherboard.

Remove the two 3.65 mm screws on the motherboard with a PH1 screwdriver.

Use an anti-static wrist strap to prevent damage to the motherboard.

Step 6

              Keypad/Plastic Display Screen
  • The keypad lies on the top of the motherboard and is easily detachable.
  • Remove the keypad.

The keypad lies on the top of the motherboard and is easily detachable.

Remove the keypad.

Step 7

  • Replace the plastic display screen, or the keypad buttons as needed.

Replace the plastic display screen, or the keypad buttons as needed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Katty

Member since: 08/27/2015

313 Reputation

                                      3 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       USF Tampa, Team 1-1, Sullivan Spring 2016                        

                                                  Member of USF Tampa, Team 1-1, Sullivan Spring 2016 



                    USFT-SULLIVAN-S16S1G1                     


                                            4 Members                     


                                            10 Guides authored