Difficulty

Moderate

Steps

6

Time Required

                          10 - 15 minutes

Sections

1

  • Gear
  • 6 steps

Flags

0

  • BackTurntable

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Gear
  • Remove the felt pad, and put it to the side.

Remove the felt pad, and put it to the side.

1024

Step 2

  • Turn the platter so that the brass motor pulley can be seen through one of the two outer holes in the platter.
  • If the drive belt is hooked around the motor pulley, unhook it.
  • When reassembling to device, don’t forget to hook the new drive belt to the motor pulley.

Turn the platter so that the brass motor pulley can be seen through one of the two outer holes in the platter.

If the drive belt is hooked around the motor pulley, unhook it.

When reassembling to device, don’t forget to hook the new drive belt to the motor pulley.

Step 3

  • Remove the platter by grasping the platter by its two inner holes and lifting it upwards.
  • If the drive belt is unhooked and the tone arm is safely to the side, don’t be afraid to use a small amount of force in lifting the platter if necessary.

Remove the platter by grasping the platter by its two inner holes and lifting it upwards.

If the drive belt is unhooked and the tone arm is safely to the side, don’t be afraid to use a small amount of force in lifting the platter if necessary.

Step 4

  • Remove the four screws holding in the gears using a Phillips #0 screwdriver.

Remove the four screws holding in the gears using a Phillips #0 screwdriver.

Step 5

  • Remove the large white gear by pulling it upwards.
  • Remove the small white gear and base by pulling them upwards.

Remove the large white gear by pulling it upwards.

Remove the small white gear and base by pulling them upwards.

Step 6

  • Insert the small replacement gear first, then the large replacement gear second.
  • When replacing the smaller gear and base, be sure to feed the black ground wire through the hole in the base.

Insert the small replacement gear first, then the large replacement gear second.

When replacing the smaller gear and base, be sure to feed the black ground wire through the hole in the base.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Devon Ferreira

Member since: 03/22/2021

133 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       UMass Dartmouth, Team S1-G8, Sinclaire Spring 2021                        

                                                  Member of UMass Dartmouth, Team S1-G8, Sinclaire Spring 2021 



                    UMASSD-SINCLAIRE-S21S1G8                     


                                            1 Member                     


                                            1 Guide authored