Autosampler Configuration For Node Control For Old New Versions Repair Guide

Difficulty

Moderate

Steps

2

Time Required

                          5 minutes            

Sections

1

• Autosampler Configuration for Node Control (For Old & New Versions)
• 2 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackOpen-Storm Hardware

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Step 1

              Starting the configuration process.               

• 1. Turn on the autosampler. Screen will read “…STANDBY…”
• 2. Press “ENTER/PROGRAM” button. Use arrows to highlight “CONFIGURE”. Press “ENTER/PROGRAM” button
• This will allow you to use the arrows to shuffle through the different configuration options. To select the one you want, press the “ENTER/PROGRAM” button.
• 3. Use arrows to find “EVENT MARK”. Press the “ENTER/PROGRAM” button.

1. Turn on the autosampler. Screen will read “…STANDBY…”

2. Press “ENTER/PROGRAM” button. Use arrows to highlight “CONFIGURE”. Press “ENTER/PROGRAM” button

This will allow you to use the arrows to shuffle through the different configuration options. To select the one you want, press the “ENTER/PROGRAM” button.

3. Use arrows to find “EVENT MARK”. Press the “ENTER/PROGRAM” button.

1024

Step 2

              Configuring "event mark".               

• 4. Use arrow to select “CONTINUOUS SIGNAL”. Press “ENTER/PROGRAM” button.
• 5. Use arrow to select “PUMP CYCLE”. Press “ENTER/PROGRAM” button.
• It is critical this setting is configured in order for the sensor node to operate the autosampler!
• 6. Use arrows to find “EXIT CONFIGURATION.” Press “ENTER/PROGRAM” button. This will bring up the screen “…STANDBY…

4. Use arrow to select “CONTINUOUS SIGNAL”. Press “ENTER/PROGRAM” button.

5. Use arrow to select “PUMP CYCLE”. Press “ENTER/PROGRAM” button.

It is critical this setting is configured in order for the sensor node to operate the autosampler!

6. Use arrows to find “EXIT CONFIGURATION.” Press “ENTER/PROGRAM” button. This will bring up the screen “…STANDBY…

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 1 other contributor 

                    Brooke Mason                     

Member since: 05/29/2019

2,928 Reputation

                                      17 Guides authored                  



                       Badges:
                       21







                                                        +18 more badges                           

Team

                       Open-Storm                        

                                                  Member of Open-Storm 



                    Community                     


                                            14 Members                     


                                            24 Guides authored