Difficulty
Easy
Steps
6
Time Required
15 - 20 minutes
Sections
2
- Red Interface Plate
- 4 steps
- Buttons
- 2 steps
Flags
0
BackAxess SPBT1031
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Red Interface Plate
- Use a metal spudger to remove the mesh speaker covers (the side with the buttons) by wedging the narrow end into the center of the outer edge of the mesh, touching the red plate.
Use a metal spudger to remove the mesh speaker covers (the side with the buttons) by wedging the narrow end into the center of the outer edge of the mesh, touching the red plate.
1024
Step 2
- Remove the four 5 mm screws from the red panel under the mesh using a Phillips #1 screwdriver.
Remove the four 5 mm screws from the red panel under the mesh using a Phillips #1 screwdriver.
Step 3
- If the screws are difficult to remove, use a pair of tweezers to twist and pick them out.
If the screws are difficult to remove, use a pair of tweezers to twist and pick them out.
Step 4
- Separate the red interface plate from the black face plate by pulling them apart.
Separate the red interface plate from the black face plate by pulling them apart.
Step 5
Buttons
- Take the red plate and the motherboard and pull apart.
Take the red plate and the motherboard and pull apart.
Step 6
- Push the set of buttons inward from the outside of the red plate and peel off from the inside.
Push the set of buttons inward from the outside of the red plate and peel off from the inside.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 6 other contributors
Elvira Lou Evangelista
Member since: 03/09/2016
950 Reputation
6 Guides authored
Badges:
16
+13 more badges
Team
UMass Dartmouth, Team 8-6, Botvin Spring 2016
Member of UMass Dartmouth, Team 8-6, Botvin Spring 2016
UMASSD-BOTVIN-S16S8G6
3 Members
8 Guides authored