Difficulty

Moderate

Steps

10

Time Required

Suggest a time??

Sections

2

  • Back Cover
  • 4 steps
  • Camera
  • 6 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Confusing Text

Some of this guide’s text is confusing, duplicated, or off-topic. Clarify it by editing!

  • BackAxess TA2513-10WT

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Lay the tablet down on a flat surface with the screen facing up, and the external camera facing upwards and closest to you.

Lay the tablet down on a flat surface with the screen facing up, and the external camera facing upwards and closest to you.

1024

Step 2

  • Insert the plastic opening tool in the space between the screen and the back cover above the volume buttons.
  • Slide the plastic opening tool gently along the sides.
  • If a small gap is not created between the screen and the back cover, pry gently upward at each of these latching points.

Insert the plastic opening tool in the space between the screen and the back cover above the volume buttons.

Slide the plastic opening tool gently along the sides.

If a small gap is not created between the screen and the back cover, pry gently upward at each of these latching points.

Step 3

  • Place the spudger in an open space to keep the back case from shutting while you continue to slide the opening tool.

Place the spudger in an open space to keep the back case from shutting while you continue to slide the opening tool.

Step 4

  • Remove the back cover with your hands once all points have been unlatched. It should separate completely from the screen that contains the battery and chip components.

Remove the back cover with your hands once all points have been unlatched. It should separate completely from the screen that contains the battery and chip components.

Step 5

              Camera
  • Remove the left screw of the plastic camera casing using the magnetic screwdriver.

Remove the left screw of the plastic camera casing using the magnetic screwdriver.

Step 6

  • Remove the bottom screw of the plastic camera casing with the magnetic screwdriver.

Remove the bottom screw of the plastic camera casing with the magnetic screwdriver.

Step 7

  • Remove the entire plastic cover using either tweezers or your fingers.

Remove the entire plastic cover using either tweezers or your fingers.

Step 8

  • Brush the surfaces of the cameras to remove any debris that is present.

Brush the surfaces of the cameras to remove any debris that is present.

Step 9

  • Grasp the black plastic cover that is attached to the ribbon cable, and rotate it 90 degrees upwards using the tweezers.

Grasp the black plastic cover that is attached to the ribbon cable, and rotate it 90 degrees upwards using the tweezers.

Step 10

  • Remove the ribbon cable from the port.

Remove the ribbon cable from the port.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Steven Kavanagh

Member since: 03/24/2015

301 Reputation

                                      3 Guides authored                  



                       Badges:
                       3

Team

                       Baylor, Team 6-3, Shaver Spring 2015                        

                                                  Member of Baylor, Team 6-3, Shaver Spring 2015 



                    BU-SHAVER-S15S6G3                     


                                            3 Members                     


                                            10 Guides authored