Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

2

  • General Disassembly Prerequisite Guide
  • 4 steps
  • Charger Port
  • 3 steps

Flags

1

Missing Details

Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.

  • BackAzpen A701

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

A guide to soldering can be found on iFixit’s website here.

What you need

Step 1

              General Disassembly Prerequisite Guide
  • Remove the two 2cm screws on the bottom using the PH0 Phillips head screw driver.

Remove the two 2cm screws on the bottom using the PH0 Phillips head screw driver.

1024

Step 2

  • Pry open back piece with plastic spudger.
  • Remove the back piece of the device.
  • The back panel may be difficult to pry off, use gentle force.

Pry open back piece with plastic spudger.

Remove the back piece of the device.

The back panel may be difficult to pry off, use gentle force.

Step 3

  • Disconnect speaker (which is attached by black and red wires) from back piece using plastic spudger.

Disconnect speaker (which is attached by black and red wires) from back piece using plastic spudger.

Step 4

  • Gently pry the battery off of the device with the plastic spudger.
  • There is a large amount of glue holding the battery to the device.
  • Do not puncture the battery with the plastic spudger.

Gently pry the battery off of the device with the plastic spudger.

There is a large amount of glue holding the battery to the device.

Do not puncture the battery with the plastic spudger.

Step 5

              Charger Port
  • The charger port is located on the underside of the motherboard (as pictured).

The charger port is located on the underside of the motherboard (as pictured).

Step 6

  • Remove the charger port by using tweezers and gently pulling.

Remove the charger port by using tweezers and gently pulling.

Step 7

  • Solder and place new charger port.

Solder and place new charger port.

To reassemble your device, snap back piece on to the front piece and screw in both 2cm screws at the bottom.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Michael

Member since: 03/11/2015

568 Reputation

                                      4 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges

Team

                       Colorado Springs, Team 2-1, Panko Spring 2015                        

                                                  Member of Colorado Springs, Team 2-1, Panko Spring 2015 



                    UCCS-PANKO-S15S2G1                     


                                            3 Members                     


                                            12 Guides authored