Difficulty
Moderate
Steps
4
Time Required
Suggest a time??
Sections
1
- Speaker
- 4 steps
Flags
Missing Details
Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.
BackAzpen A701
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Speaker
- Wedge plastic spudger in between the back panel and the speaker of the device.
Wedge plastic spudger in between the back panel and the speaker of the device.
1024
Step 2
- Gently pry out the speaker from the back panel using the plastic spudger.
Gently pry out the speaker from the back panel using the plastic spudger.
Step 3
- Heat solder and apply to the wires where they attach to the motherboard. This will disconnect the wires from the motherboard.
- The wires should still be attached to the speaker.
Heat solder and apply to the wires where they attach to the motherboard. This will disconnect the wires from the motherboard.
The wires should still be attached to the speaker.
Step 4
- Take the speaker and wires that are attached out of the device and insert a new speaker by soldering the wires to the motherboard.
Take the speaker and wires that are attached out of the device and insert a new speaker by soldering the wires to the motherboard.
To reassemble your device, snap back piece back on to device and secure both 2cm screws at the bottom.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Grant Harding
Member since: 03/11/2015
249 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
Colorado Springs, Team 2-1, Panko Spring 2015
Member of Colorado Springs, Team 2-1, Panko Spring 2015
UCCS-PANKO-S15S2G1
3 Members
12 Guides authored
