Difficulty

Moderate

Steps

8

Time Required

Suggest a time??

Sections

2

  • Back Cover
  • 3 steps
  • Battery
  • 5 steps

Flags

0

  • BackAzpen A720

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Use a Phillips #00 screwdriver to remove the two 4mm screws found on the top edge of the tablet near the power button.

Use a Phillips #00 screwdriver to remove the two 4mm screws found on the top edge of the tablet near the power button.

1024

Step 2

  • Use the plastic opening tool to pry the white back from the silver frame. Start near the micro SD slot.
  • Slide the plastic opening tool around the perimeter of the casing until the back is disconnected.

Use the plastic opening tool to pry the white back from the silver frame. Start near the micro SD slot.

Slide the plastic opening tool around the perimeter of the casing until the back is disconnected.

Step 3

  • Remove the rear casing.

Remove the rear casing.

Step 4

              Battery
  • Locate the batteries’ connection points.

Locate the batteries’ connection points.

Step 5

  • A soldering iron can reach 600˚ F, which will cause serious burns. Learn how to solder properly here. Using tweezers to hold the wires will reduce the risk of burns.
  • Use a soldering iron to melt the connections which attach the battery to the motherboard.
  • Disconnect the red and black wires from the motherboard.

A soldering iron can reach 600˚ F, which will cause serious burns. Learn how to solder properly here. Using tweezers to hold the wires will reduce the risk of burns.

Use a soldering iron to melt the connections which attach the battery to the motherboard.

Disconnect the red and black wires from the motherboard.

Step 6

  • Peel the black sticker off the battery to disconnect the wifi antennae.

Peel the black sticker off the battery to disconnect the wifi antennae.

Step 7

  • Slide the spudger between the battery and the metal backing. Move the spudger back and forth in a sawing motion to break the adhesive seal between the battery and the backing.
  • When the spudger is underneath the battery avoid prying. A prying motion could damage the battery.

Slide the spudger between the battery and the metal backing. Move the spudger back and forth in a sawing motion to break the adhesive seal between the battery and the backing.

When the spudger is underneath the battery avoid prying. A prying motion could damage the battery.

Step 8

  • Remove the old battery and replace it with the new battery.

Remove the old battery and replace it with the new battery.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 5 other contributors 


                    Ben

Member since: 03/18/2015

280 Reputation

                                      2 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       Michigan Tech, Team 1-3, Lauer Spring 2015                        

                                                  Member of Michigan Tech, Team 1-3, Lauer Spring 2015 



                    MTU-LAUER-S15S1G3                     


                                            2 Members                     


                                            5 Guides authored