Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

2

  • Back Cover
  • 3 steps
  • Wifi Antenna
  • 3 steps

Flags

1

Missing Details

Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.

  • BackAzpen A720

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Use a Phillips #00 screwdriver to remove the two 4mm screws found on the top edge of the tablet near the power button.

Use a Phillips #00 screwdriver to remove the two 4mm screws found on the top edge of the tablet near the power button.

1024

Step 2

  • Use the plastic opening tool to pry the white back from the silver frame. Start near the micro SD slot.
  • Slide the plastic opening tool around the perimeter of the casing until the back is disconnected.

Use the plastic opening tool to pry the white back from the silver frame. Start near the micro SD slot.

Slide the plastic opening tool around the perimeter of the casing until the back is disconnected.

Step 3

  • Remove the rear casing.

Remove the rear casing.

Step 4

              Wifi Antenna
  • Locate the gray cord attached to the motherboard and the battery. This is the wifi antenna.

Locate the gray cord attached to the motherboard and the battery. This is the wifi antenna.

Step 5

  • Locate the soldering connection between the wifi antenna and the motherboard.
  • Using a soldering iron, melt the soldering connection between the cord and the motherboard and disconnect the cord.
  • The soldering iron gets very hot, be careful not to touch the tip to avoid burns. Click here to learn how to solder.

Locate the soldering connection between the wifi antenna and the motherboard.

Using a soldering iron, melt the soldering connection between the cord and the motherboard and disconnect the cord.

The soldering iron gets very hot, be careful not to touch the tip to avoid burns. Click here to learn how to solder.

Step 6

  • Locate the black sticker connecting the wifi antenna to the battery.
  • Peel the black sticker off of the battery to disconnect the wifi antenna.
  • Remove and replace the defective wire.

Locate the black sticker connecting the wifi antenna to the battery.

Peel the black sticker off of the battery to disconnect the wifi antenna.

Remove and replace the defective wire.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Anna

Member since: 03/17/2015

353 Reputation

                                      3 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Michigan Tech, Team 1-3, Lauer Spring 2015                        

                                                  Member of Michigan Tech, Team 1-3, Lauer Spring 2015 



                    MTU-LAUER-S15S1G3                     


                                            2 Members                     


                                            5 Guides authored