Difficulty
Moderate
Steps
8
Time Required
15 - 30 minutes
Sections
2
- Back Cover
- 3 steps
- Front and Rear Facing Camera Assembly
- 5 steps
Flags
1
Markup Mishap
This guide needs better markups. Help out by correcting or making some markup annotations.
BackAzpen A909
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Begin by unscrewing the two 1.4 mm diameter Phillips #00 head screws at the top of the device.
Begin by unscrewing the two 1.4 mm diameter Phillips #00 head screws at the top of the device.
1024
Step 2
- Next, gently pry the cover off with a plastic opening tool or a similar instrument by loosening all of the anchoring points. Two of the anchoring points are circled in the image. Avoid excessive bending or pivoting, since doing so may break the anchoring points.
Next, gently pry the cover off with a plastic opening tool or a similar instrument by loosening all of the anchoring points. Two of the anchoring points are circled in the image. Avoid excessive bending or pivoting, since doing so may break the anchoring points.
Step 3
- After prying open all of the anchoring points, the cover will lift off of the tablet.
- To replace the cover, simply snap it back in place and re-insert the two screws. Because the speaker is not fully fixed to the interior of the tablet, make sure that it is in the position that will allow it to fit inside the speaker mounting on the cover.
After prying open all of the anchoring points, the cover will lift off of the tablet.
To replace the cover, simply snap it back in place and re-insert the two screws. Because the speaker is not fully fixed to the interior of the tablet, make sure that it is in the position that will allow it to fit inside the speaker mounting on the cover.
Step 4
Front and Rear Facing Camera Assembly
- Using a plastic opening tool, gently peel back the black electrical tape to reveal the power strip and the front facing camera, which is marked by the red box in the image.
Using a plastic opening tool, gently peel back the black electrical tape to reveal the power strip and the front facing camera, which is marked by the red box in the image.
Step 5
- Gently pull the front facing camera out of its mounting point. Use a spudger if necessary.
Gently pull the front facing camera out of its mounting point. Use a spudger if necessary.
Step 6
- Using the spudger, pry the rear facing camera its power strip off the circuit board. This may require some force, since a strong adhesive is used to mount the camera assembly to that point.
Using the spudger, pry the rear facing camera its power strip off the circuit board. This may require some force, since a strong adhesive is used to mount the camera assembly to that point.
Step 7
- Lift open the connector flap with the spudger.
Lift open the connector flap with the spudger.
Step 8
- At this point, all points of the camera assembly should be detached from the device.
- Lift and remove the power strip/camera assembly from the device with a pair of tweezers.
At this point, all points of the camera assembly should be detached from the device.
Lift and remove the power strip/camera assembly from the device with a pair of tweezers.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Jordan
Member since: 03/15/2015
381 Reputation
2 Guides authored
Badges:
13
+10 more badges
Team
UMass Dartmouth, Team 3-5, Duarte Spring 2015
Member of UMass Dartmouth, Team 3-5, Duarte Spring 2015
UMASSD-DUARTE-S15S3G5
3 Members
12 Guides authored
