Difficulty
Very easy
Steps
3
Time Required
30 minutes
Sections
1
- broken spacer
- 3 steps
Flags
2
In Progress
This guide is a work in progress. Reload periodically to see the latest changes!
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackBaby Jojo cradle
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
broken spacer
- The upper left spacer broke into two halfes. Tape was used to try to hold the remains in place.
The upper left spacer broke into two halfes. Tape was used to try to hold the remains in place.
1024
Step 2
- The construction of the replacement part is very simple and the replacement part provides more surface and thus reduces the pressure inside the plastic material.
- Construction was done in Fusion360 and the printout with a Vertex Nano 8600.
The construction of the replacement part is very simple and the replacement part provides more surface and thus reduces the pressure inside the plastic material.
Construction was done in Fusion360 and the printout with a Vertex Nano 8600.
Step 3
- Both spacers were replaced to provide a clean look.
- Get a pair of replacement spacers shipped to your country for 7 USD/€/CHF excluding S&H by mailto:newton2k1@gmail.com
Both spacers were replaced to provide a clean look.
Get a pair of replacement spacers shipped to your country for 7 USD/€/CHF excluding S&H by mailto:newton2k1@gmail.com
Caution! Remove baby from cradle before repair.
Loose lower bolt and remove upper bolt. Replace both spacers and tighten screws moderatly. Avoid damaging the spacers.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Newton2k1
Member since: 04/29/2013
97 Reputation
1 Guide authored
Badges:
3