Backbone One Right Trigger Replacement Repair Guide

Difficulty

Moderate

Steps

9

Time Required

                          20 - 30 minutes            

Sections

2

• How to Open the Right Handle of the Backbone One
• 2 steps
• Right Trigger
• 7 steps

Flags

0

• BackBackbone One

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Remove the screws               

• Use a Phillips screwdriver to remove the four 5.9 mm-long screws.

Use a Phillips screwdriver to remove the four 5.9 mm-long screws.

1024

Step 2

              Rotate the upper part               

• Lift up the upper cover of the controller.
• Swing the upper cover over and place it on the controller case.
• Make sure that the interconnecting cable has no tension.

Lift up the upper cover of the controller.

Swing the upper cover over and place it on the controller case.

Make sure that the interconnecting cable has no tension.

Step 3

              Remove the protective tape               

• Use a pair of tweezers to remove the yellow protective tape which is placed over the interconnect cable and the connector.

Use a pair of tweezers to remove the yellow protective tape which is placed over the interconnect cable and the connector.

Step 4

              Open the interconnect cable ZIF connector               

• Use the tip of an opening pick to open the gray flap of the interconnect cable ZIF connector by pushing it upwards.

Use the tip of an opening pick to open the gray flap of the interconnect cable ZIF connector by pushing it upwards.

Step 5

              Disconnect the interconnect cable               

• Disconnect the cable by pulling it straight out the ZIF connector.

Disconnect the cable by pulling it straight out the ZIF connector.

Step 6

              Disconnect the phone connector cables               

• Use a pair of tweezers to disconnect the phone connector cables out from their sockets.

Use a pair of tweezers to disconnect the phone connector cables out from their sockets.

Step 7

              Separate the upper case               

• Separate the the upper case of the left controller handle.

Separate the the upper case of the left controller handle.

Step 8

              Remove the screws               

• Use a Phillips screwdriver to remove the three 5.9 mm-long screws.

Use a Phillips screwdriver to remove the three 5.9 mm-long screws.

Step 9

              Remove the trigger               

• Remove the trigger.

Remove the trigger.

To reassemble your device, follow these instructions in reverse order.

Opening didn’t go as planned? Answers community for help.

Cancel: I did not complete this guide.

Author

                    Adriana Zwink                     

Member since: 12/18/2019

36,607 Reputation

                                      167 Guides authored                  



                       Badges:
                       34







                                                        +31 more badges                           

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,772 Guides authored                     

pelony felony - Aug 3, 2022

Reply

where can I buy a right trigger replacement?